KCKKen's latest activity
-
KWe still talking about trucks?
-
KSo, I have felt along the wire going to the block and I detect no deviations in the wire. It may be further back in the loom. Today, I...
-
KSomeone mentioned this above. It’s a piece of wire inline with the wire it’s protecting typically two sizes smaller. If you look at your...
-
K@KCKKen I was wondering about this too. ^^^
-
KYou are spot on. I just remembered that I had to weld the replacement for the original batt tray. Once I remembered that, it made sense...
-
KWhat made you decide to go 5.7 olds?
-
KKCKKen replied to the thread Aux Battery Tray local.Hi Ricko! I have about a dozen of them in storage, and have years of experience with them (mom worked for an Olds dealer here in Kansas...
-
KKCKKen reacted to idahovette's post in the thread New tach conversion kit from usa1 how to mount the tach to the mounting bracket with
Haha.
Been using my "OLD" nuts for years -
KI located my lift in the garage specifically to lift Ralph up for service
-
KThe stock inlet/cover on a V8 is on the passenger side, but on 6 cylinder it’s on the driver’s side. Some folks set it up for a dual...
-
KKCKKen replied to the thread Aux Battery Tray local.I believe the auxiliary battery location would have been the primary battery location for the Olds 5.7 Diesel too -- I need one so I can...
-
KWell, I picks me self up a nutsert tool. What a slick little gizmo. Drill a hole, squeeze in a nut. Nice!
-
KThanks, I jumped back on here to say, I found the spot. I was expecting holes to already be there, but they are not. There are "dimples"...
