Recent content by JD Miller
-
350 bearings questions
Google: Got calipers? :gr_grin: :cool:- JD Miller
- Post #2
- Forum: Engine & Performance
-
-
1978 chevy 350 issue
You mean Class 1 ? ? ? looks like many class 1 cams https://www.melling.com/parts-lookup/- JD Miller
- Post #13
- Forum: Engine & Performance
-
Ford Trash Talk Thread lol
Have you noticed the sound of a Ford duramax diesel truck drive by with the driver accelerating ? Sounds like the thing is going to blow-up, sputtering like a dinosaur with diarrhea farts :happy175:- JD Miller
- Post #584
- Forum: Other Vehicles
-
2005 Ram 2500 Free Spin Install & Other Goodies
Did you get the DynaLoc hubs or Warn Hubs kit? There are a few free spin kit manufacturers , not sure which is better, if any.... Why did you pick the DynaTrac ? You got any any knowledge of the other kits? I think I was looking at getting the Dynatrac, cant remember my research or why though- JD Miller
- Post #16
- Forum: Other Vehicles
-
2005 Ram 2500 Free Spin Install & Other Goodies
Just found this thread. I have the same 05 dodge but mine is a 3500. That should have came with a posi rear. Ive been thinking about doing a front locking hub kit. My '99 CTD 4x4 dana 60 has the sliding collar disconect What the hell happened to that front carrier?- JD Miller
- Post #15
- Forum: Other Vehicles
-
Inside the steering column, what is the steering "rack?"
Its kind of a Pain in the Arse to replace. But not that bad. Pull you steering wheel and just start taking apart till you get to it. Careful you might have one or two bearings fall out, so put a large plastic dish tub on you floor board to catch balls. Put some fresh lithium grease in the...- JD Miller
- Post #4
- Forum: Suspension, Steering & Brakes
-
Inside the steering column, what is the steering "rack?"
Ive replaced that thing. It broke . Could not start the truck You have to take it apart. Careful not to loose any of the ball bearings. I bought my rack kit at Autozone over the counter. It was only about $10 LMC has it for $13.50...- JD Miller
- Post #3
- Forum: Suspension, Steering & Brakes
-
-
Hello from Arlee,Montana
Need pictures or it didnt happen :shrug: :gr_grin:- JD Miller
- Post #5
- Forum: Introduction
-
Headers or manifolds for 86k10 350 w/ Vortec heads?
Im running Doug Thorley headers :waytogo:- JD Miller
- Post #3
- Forum: Tech Discussion
-
Show your daily driver
'05 3500 Dodge Cummins and the '81 K20. Also have a '99 dodge cummins- JD Miller
- Post #858
- Forum: Other Vehicles
-
3+3 for sale
There is a couple 4 doors forsale around here, but probably rusted and never taken care of junkers
