JD Miller's latest activity
-
JD Miller reacted to PrairieDrifter's post in the thread Can I use this hole for filling oil? with
Wow.
10,000..? -
JD Miller replied to the thread Finally got a new mig welder.Heah, where'd you get that cart.:think: I like that and the draws/storage. I got the heavyduty cart from Harborfreak . .
-
I never wear gloves. I get yelled at by my boss because i dont.
-
JD Miller replied to the thread Finally got a new mig welder.Yup, spend the money and get a good brand welder, Miller Hobart, Lincoln.
-
If and/or when you do,do not buy a cheap one. The difference is night and day,a cheap one you'll just think you suck at welding, a good...
-
JD Miller replied to the thread Bare Hands.I R&Red my front drive shaft on my k20, and replaced the pinion yoke seal on the front 4x4 axle. Cleaned the crud off washed and painted...
-
Do you work on stuff with your Bare Hands ? :waytogo:.... I sure do. Dirt, Oil, and Grease dont scare me :Big Laugh::happy107: I see...
-
Yeah ! :party33::party33::pepper::party36: I finally replaced my mig welder I sold when I moved Millermatic 211
-
JD Miller replied to the thread Pulling all the smog stuff.1987 was after smog was cured and before climate changed and killed White lemuroid ringtail possums and polar bears :Big Laugh:
-
JD Miller replied to the thread Shop heater.Need Electric heater No Natural gas here. House has 250 gal propane tank, and to far from shop. Propane is expensive. Summer $2.40 per...
-
What do you have for a shop heater? I might do a electric shop heater, thought about a pellet stove, put just want "easy peesy" push...
-
JD Miller replied to the thread What will cause this to happen in a 208 Transfer Case (Pic Inside).Rats gnawing on your plastic gear
-
JD Miller replied to the thread New Front Drive Shaft, '81 K20.Puttin in a new front axle pinion seal while I gotz my old drive sahft off, before I putz my new drive shaft on. Transfer case front...
