JBswth's latest activity
-
JJBswth reacted to CalSgt's post in the thread ANYONE USED VORTEC HIGH SWIRL HEADS ON THEIR GEN-I SBC? with
Like.
IIRC to run the Vortec heads you would need an intake manifold and because Vortec water pump uses a bypass hose a small hole needs to... -
JLEDs (light emitting diodes) Diodes only allow current to go one direction. Using them in dash lights generally isn't an issue. If...
-
JI have replaced many bulbs in old squarebodies. I also upgrade to LEDS for the difference in brightness. I have found through trial and...
-
JThe twist-in bulb holders are replaceable. You can also take a pencil eraser and gently clean the area they contact the printed...
-
JMost of the time the printed circuit board is wore a bit where the bulb sockets twist onto the gauge panel. Sometimes, if you have a...
-
JWhen you get to the knock stage pull 1 plug wire off at a time and put it back on and if the knock goes away on any of the cyl...
-
JDefinitely change the oil and filter now and check for shiny bits in the drain pan. I've never cut open a filter, but that may be a...
-
JJBswth replied to the thread Big block running hot. Can’t figure out the issue.But they didn't match the originals as far as the number of holes.
-
JJBswth replied to the thread Can't decide what to do. Suggestions? Thoughts?.I would just stick with stock. There is nothing wrong with the Chevy 350. They are easy to rebuild, and you won't have to worry about...
-
JJBswth reacted to thedog52's post in the thread Can't decide what to do. Suggestions? Thoughts? with Like.
Hello all. I have a 1991 Suburban 2500. It has the 350 TBI, and 4L80. It is 4X4. It is dead nuts reliable. I drove it to Florida lasy...
-
JJBswth reacted to Ricko1966's post in the thread 700r4 TV cable cause acceleration/run away with 6.2? with Like.
I've had a diesel run away by sucking crankcase oil. It's not likely,but you should read up on it,and check your intake for engine oil...
-
JJBswth replied to the thread 3.08 Gears. What to Swap to?.I wouldn't go deeper than 3:73 with automatic. J. B.
-
JGet a tach,drive your truck,note your rpms at different speeds. Then look at an online gear ratio calculator,see how many rpms you will...
-
JFreeze plug/soft plug. Same thing. Softer than the engine block lol
-
JI've started my wore out carbed 350 in -50F and colder. I daily my square in ND all year round. Good battery and cables and proper choke...
