JBswth's latest activity
-
JJBswth replied to the thread Can I use this hole for filling oil?.You are NEVER supposed to go 10,000 miles between oil changes, unless you really like frequently rebuilding your engine. J. B.
-
JWouldn't cut the baffle out unless necessary. PVC will suck oil or possibly spray out on breather side. Once it's out it's gone.
-
JYou can definitely fill oil through those. However, some cheaper covers occasionally have a baffle that doesn't flow oil as well as...
-
JJBswth replied to the thread Building a new motor for my 79 C10 - would love some advice!.Depends on what you are going to use it for and what kind of power you want. I first would think about the differential gearing. Your...
-
JWhat I normally do,build my combo,measure for a drive shaft and head to pik n pull armed with a tape measure. I can usually find...
-
JJBswth reacted to NickTransmissions's post in the thread From 350 trans to 400 transmission with
Like.
Have your existing drive shaft cut and rebalanced or a performance driveshaft made ss mentioned above. Trans cross member will need to... -
JJBswth reacted to molus's post in the thread after doin front end clutch and steering column,truck feels like its in 4wd with Like.
Old brake lines breaking down, they swell and let fluid through due pressure applied but won’t relax enough to let the pressure back out...
-
JJBswth reacted to PrairieDrifter's post in the thread after doin front end clutch and steering column,truck feels like its in 4wd with Like.
Any brakes staying on is usually a bad rubber hose. I have had a caliper seize before once my pads got too wore out it stuck the caliper...
-
JTH400 kick down solenoid has a single wire connection on the drivers side of the unit. I believe the wire is routed along with the...
-
JOn a TH400 there is an electrical switch that goes through the case near the valve body. I don't remember exactly, but it hooks onto...
-
JThey are small abrasive hones for use on valve body and pump bores where valves are located. Same concept as bottle brush hones for...
-
JHey man, responded to your post on Youtube - here's the copy: I'm thinking either kick down cable possibly out of adjustment, kick-down...
-
JMy '74 is a camper special. It has brackets on the front fenders for a slide on & over the cab camper, it came with towing mirrors...
-
JWe don't live in a HOA and there are still Karen's that think they run the world. I was turned into the city by one of them. Provided...
-
JJBswth replied to the thread Collapsed upper radiator hose.You need a new radiator cap. Also, see if you can buy hoses with a spring inside. That spring prevents collapsing. J. B.
Latest posts
-
-
-
-
98' Vortec Block, Timing Cover and Balancer Spacing Questions.- Latest: RanchWelder
-
