JamesSam's latest activity
-
JamesSam replied to the thread What have you done to your square lately??.Ok what tool will I need to to clamp in a long straight pipe with a coupling section on each end? I am planning to rent a pipe cutting... -
JamesSam replied to the thread What have you done to your square lately??.Wow. What does this mean for horsepower if i go straight pipe? Will it sound different?
-
JamesSam reacted to ChuckN's post in the thread What have you done to your square lately?? with
Like.
Looks like you’re exempt... -
JamesSam replied to the thread What have you done to your square lately??.1)The only reason I would replace the cat is because I assume VA law would say I need to. And yes I have been looking at general...
-
JamesSam reacted to Grit dog's post in the thread What have you done to your square lately?? with Like.
I wouldn’t bother saving the cat if it were me. It’s obviously not original and may be fine, but whatever. Just replace it with a...
-
JamesSam replied to the thread What have you done to your square lately??.Good looks there Chad, thank you. My Uncle told me to try almost the exact same process. I'm gonna see what I can do tomorrow.
-
JamesSam reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Doesn’t *look* that bad. Get that clamp off and then give it a good wiggle. Just depends on how much the crimp created by the clamp...
-
JamesSam replied to the thread What have you done to your square lately??.So I started taking the u bolts off either side of the cat. I had PB Blaster soaking on them since yesterday. While I got those free...
-
-
JamesSam replied to the thread What have you done to your square lately??.Thanks!!
-
JamesSam reacted to Strick's post in the thread What have you done to your square lately?? with Like.
Bed cross-rail. Here’s an underneath shot. Use the fuel fill door for reference.
