JamesSam's latest activity
-
JamesSam reacted to Ajax19's post in the thread What have you done to your square lately?? with
Like.
TIME-SERT 7/16-14 SAE Thread Repair Kit https://a.co/d/32d6sQd These will be better than new there's a guy on YT that I recommended... -
Thanks for sharing guys!!
-
JamesSam reacted to BigT's post in the thread New to the forum, but not to Squarebodies... with Like.
Oh right, I have one of those for my 64 Chevelle, but not for this truck. I forgot the terminology! Clearly I have been away from this...
-
JamesSam reacted to Keith Seymore's post in the thread New to the forum, but not to Squarebodies... with Like.
Thank you for posting that; that is what is known as a SPID label (Service Parts ID label). The build sheet is what the line workers...
-
JamesSam reacted to 86 C10 Shortbed's post in the thread New to the forum, but not to Squarebodies... with Like.
Welcome from Central Ohio
-
Back to like new ... Did replace the solenoid with a new one just because the old one has a lot of years under it's belt and a new...
-
Ah a growler and a mica undercutter/lathe!
-
Since the starter was off the motor, thought it would be wise to take a look at it's guts ... A little clean up won't hurt a thing...
-
JamesSam reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Might not work if they are cast iron but you could take a punch and peen it if they are aluminum I'd give it a shot another option is to...
-
JamesSam reacted to Doppleganger's post in the thread What have you done to your square lately?? with Like.
Is that Rino liner on your bed walls? Looks great!
-
JamesSam reacted to bucket's post in the thread What have you done to your square lately?? with Like.
I also had one come out of place years ago, I just hammered it back in and it was fine after that. They were even heads that I had...
-
JamesSam reacted to Truck82's post in the thread What have you done to your square lately?? with Like.
No I hade to find and buy everything separately. LMC has it all
-
JamesSam reacted to Bloodhound1981's post in the thread What have you done to your square lately?? with Like.
After 3 months on backorder, the Holley rubber bed mat finally arrived. This thing is beefy!
-
JamesSam reacted to Normmus's post in the thread What have you done to your square lately?? with Like.
Are you using a kit that includes all the parts?
-
JamesSam reacted to ChuckN's post in the thread What have you done to your square lately?? with Sad.
Looks like I’m going into long hibernation mode until I can figure out what my next plan is. I happened to notice a couple rocker arm...
