HotWheelsBurban's latest activity
-
HHotWheelsBurban reacted to TotalyHucked's post in the thread What new tools have you got lately? with
Like.
Haha I did bring that trim up again yesterday just for good measure. I wasn't shot down but wasn't given the green light either -
HHotWheelsBurban reacted to Camar068's post in the thread What new tools have you got lately? with Like.
cheap lift for whatever. Bed lift mounted to garage ceiling, deer winch for bed....w/e. Cheapest I've seen it. HF 2000 $55
-
HHotWheelsBurban reacted to 77 K20's post in the thread K5 Blazer values… possibly buying 86 k5 with Like.
Looks to be in pretty nice shape compared to some I've seen out there lately. It has the manual crank rear window- which I like. The...
-
HStill got this to measure from fender to ground at center of hub? Hoping I'll get lucky with the new monroe coil overs and have...
-
HYep. If you want to, shoot me a text about 8 tomorrow morning so I remember to measure it. Otherwise it'll be dark when I get home after...
-
HHotWheelsBurban reacted to Craig Nedrow's post in the thread Custom fabric inlays on dash side panels- how to attach fabric? with Like.
I once used that 3M stuff on my bosses chair, cause he ticked me off for pickin on a kid. put on two coats, ten minutes later, came...
-
HHotWheelsBurban replied to the thread Searching for My Dad's 1979 Chevy Suburban.We paid $1500 for ours in September 1989. No AC, the compressor was gone, and it had crank windows so we tried not to get stuck in...
-
HHotWheelsBurban reacted to TheHoundsman's post in the thread Searching for My Dad's 1979 Chevy Suburban with Like.
I found this one as well. The color is not the same on this one but it is a MT and does have the mounting for the third row. It looks...
-
HHotWheelsBurban reacted to WFarm's post in the thread What new tools have you got lately? with Like.
15 or so years ago I was one of the technical leads for a planned radial bearing replacement on an Allis-Chalmers reactor coolant pump...
-
HHotWheelsBurban reacted to waterpirate's post in the thread What new tools have you got lately? with Like.
Was on a job with a farm mechanic Tuesday. 1 ton flat bed shorty decked out with boxes welders the works. He opened the side box to...
-
HHotWheelsBurban reacted to TotalyHucked's post in the thread What new tools have you got lately? with Like.
Talk about a bad day, bet there were lots of 4 letter words said that day. I've had 2 dead blows break on me like that, one just sent...
-
HIt will come out easily, over the rail bedliners typically installed with some screws and twist to lock anchors. Usually the only...
-
HIt can go either way, I've seen some trucks that are mint underneath those other than rubbed through paint and I've seen some where the...
-
HThanks for the encouragement. I'll yank it out and see what's what. I'm just nervous about what I might find...
-
HI had one in my truck for years. When I pulled it out it was mint underneath. Eric Good luck
