Grit dog's latest activity
-
Grit dog replied to the thread What have you done to your square lately??.In general, yes. Although alternator could have just now kicked the bucket. And be the cause of <12v on the gauge. But not likely cause... -
Grit dog reacted to Travlr's post in the thread What have you done to your square lately?? with
Like.
If the starter motor will crank to start, then a vehicle will run on the battery for a long ways. -
Grit dog replied to the thread Muffler recommendations.Edit
-
Grit dog replied to the thread Where is this interior leak coming from?.Good work so far. My only comment is I feel fortunate (knock on wood) that both squares are leak free and appear to have been since new...
-
Grit dog replied to the thread Heater core replacement.lol…. Not totally understanding. Are you asking about the firewall and floor insulation? If so, dynamat or similar would work just fine...
-
here is a couple pics. Didn't have one in earlier post.
-
Second story: There are some "architectural" things we did, too, that you might not notice. These were required to even give us a shot...
-
Grit dog replied to the thread What have you done to your square lately??.Weird ain’t it?
-
Grit dog replied to the thread Dual fuel tanks and valves.They’re all in the same spot. And if un fcked with, have a tin cover over it that is a challenge to get at all the bolts (but possible...
-
Grit dog replied to the thread Car Hauler tips/tricks/ideas.Agree, that would be “best”. It will absorb moisture from the uncoated underside. But not practical to remove the deck for that. And...
-
Grit dog reacted to mxer147's post in the thread What have you done to your square lately?? with Like.
I’m not restoring it to show condition so I plan to leave my personalized flaws in the paint. Considering it’s a driveway DIY paint job...
-
Grit dog replied to the thread What have you done to your square lately??.I agree, almost 100%. A lot of “issue” with things is perception and reasonably enough, a group like us here are more old school than...
-
Grit dog replied to the thread Filling in seams.Picture time. If it’s truly up to 1/8” off, that’s a lot. I checked my trucks and one of them is not perfect, maybe 1/16. The other is...
-
Grit dog replied to the thread A very expensive and dumb mistake (update I was wrong).Yes but that’s less than an inch offset so effectively less than half inch offset in the driveshaft. If the OP pic is 100% correct...
-
I would like to, but my rims might not be wide enough to mount those tires up properly. Their website says minimum rim width 8 inches. I...
