gmbellew's latest activity
-
Ggmbellew replied to the thread 1987 454 TBI stalls at idle after a short time.I think some of the 454s idled in open loop as a matter of the stock PROM. So open loop idle might not be anything to worry about.
-
Ggmbellew replied to the thread 1987 454 TBI stalls at idle after a short time.I've had intermittent short to ground issues on ECMB and ECMI circuits kill the engine. usually it blows a fuse. but sometimes I think...
-
Ggmbellew replied to the thread 1987 454 TBI stalls at idle after a short time.this is a direct link- http://aldlcable.com/aldl.asp also you can check out...
-
Ggmbellew replied to the thread What have you done to your square lately??.not sure what the issue is, but TBI > Carb. diagnose whatever the issue is and fix the TBI
-
Ggmbellew replied to the thread 86 1/2 ton gears needed for 33” with new 383.there is a rare 4.30ish something, but it isn't commonly available. with 32-33in tires, that would just about put it like stock tires...
-
Ggmbellew replied to the thread Dakota Digital RTX gauge cluster.maybe it is intentionally off center and at an angle to allow better viewing of the lower left gauge spot from the drivers point of view.
-
Ggmbellew replied to the thread 86 1/2 ton gears needed for 33” with new 383.I have 350tbi/4L60/3.73 in my burb with "33's" that actually tape out around 32 inches. it is adequate enough that I won't likely...
-
Ggmbellew replied to the thread LED Issues.I plan to stick with incandescent bulbs for brakes/blinkers because of these sorts of issues. I just don't see the huge upside with LED...
-
Ggmbellew replied to the thread 1987 V3500 Engine update.out of curiosity, why aren't you sticking with the TBI?
-
Ggmbellew replied to the thread Replace Gauge Needle.you can replace it if you can find one. you can gently pry them off with a fork. it is just a friction fit. or you may be able to glue...
-
Ggmbellew replied to the thread 1987 V3500 Engine update.Keep us posted on that new block! That is the same one I have my eye on when the time comes for me.
-
GNo it's not just a fuse,fuses don't just get old and quit. If the fuse popped it popped for a reason,you need to find,what overloaded...
-
Ggmbellew replied to the thread 89 Suburban 5.7 blowing fuse #5 GAGE/IDLE.I'd guess that your manipulation of the harness moved the purple wire off it's short to ground for the mean time. Go out at night and...
-
Ggmbellew replied to the thread 89 Suburban 5.7 blowing fuse #5 GAGE/IDLE.Mine was rubbed through on this bracket right above the TCC connector in the photo. You might just move the harness a little to make...
-
-
Ggmbellew replied to the thread 89 Suburban 5.7 blowing fuse #5 GAGE/IDLE.by the transmission. driver side. rubbed on the bracket before the TCC solenoid switch.
