fast 99's latest activity
-
fast 99 replied to the thread Oil Pressure Drops After High RPM.Have seen Lucas at local stores. Another place to check is Walmart. OP when you drain the 5-30 out take a stick or screwdriver and... -
Low knock at idle,with low oil pressure,is usually main bearings. Put a good mechanical oil pressure gauge on it to confirm readings I...
-
fast 99 replied to the thread Oil Pressure Drops After High RPM.Were on the same page. Actually, most 5-30 oils shouldn't be used with flat tappet cams, additive package is wrong.
-
fast 99 replied to the thread Oil Pressure Drops After High RPM.Change to a thicker oil 10-30 or 10-40. If it continues need to confirm with mechanical gauge. If indeed pressure is that low how old is...
-
fast 99 replied to the thread LMC Dash Pad Supplier.I purchased a pad, from Jegs. Was double boxed with a Dashes direct part inside. Shipping was either free or substantially less than...
-
fast 99 replied to the thread 350 tbi running too cold.Also keep in mind where the sender is. If in head it will read about 10 degrees hotter than near the stat in the intake. Really cheap...
-
The problem with USA1 is they take your money immediately but then cannot supply the item. They’ll say 16 weeks and 18 months later...
-
If its running less than 195 with a 195 stat, the stat is bad, the sending unit is bad or your gauge is defective.
-
If the truck is still driveable, take somewhere to have the system evacuated. That will answer 2 big questions: does the system still...
-
fast 99 replied to the thread A/C Question.It's not difficult but some procedures need to be followed. Any part not replaced needs to be flushed of oil and contaminates. In...
-
fast 99 replied to the thread First real drive! Not tragic but not good. I think I need carb advice..A couple pictures would help. Obviously with headers the heat riser valve is gone. That effects intake preheat and choke operation. Hard...
-
fast 99 replied to the thread Weird leak...Have seen coolant leaks that only occur when vehicle is cold, especially plastic tank radiators. Holding pressure for long periods...
-
fast 99 replied to the thread First real drive! Not tragic but not good. I think I need carb advice..Before thinking about buying parts some diagnosis first. Check over the tune up, good plugs not fouled, timing, both advances, inspect...
-
Pack the wheel bearings with grease but not the locking hub parts. Heavy grease will cause Spicers to stick and not move like they...
-
fast 99 replied to the thread LMC Dash Pad Supplier.Can't remember which vendor I got mine from but it came double boxed with dashes direct part inside. It was for an 81 fit was eh.
