fast 99's latest activity
-
fast 99 replied to the thread 1985 Long Bed Floor and Bedsides.Beautiful truck and black shows everything. Already have an AMD floor. Bed sides have too many repairs [mud] to ever look good even in... -
-
Yeah and alot of the squarebody panels were junk for a long time, what we refer to as "crash parts". We reverse engineered off good...
-
fast 99 replied to the thread 1985 Long Bed Floor and Bedsides.Good to know. OEM fit would be great. Have been there done that trying to install poor reproduction parts.
-
fast 99 replied to the thread CARBURETOR DATED.Really sounds like a hot soak problem. Check fuel pressure and float setting. If that's ok try non-ethanol fuel. I have the same issue...
-
fast 99 replied to the thread 1985 Long Bed Floor and Bedsides.Let us know how the bed sides fit and quality. I will need both at a later date.
-
fast 99 replied to the thread 1973 k20 350 intermittent bogging under load.I bought 2 pumps in a row that went bad in less than 60 miles. If pump ends up being bad buy Delco, Delphi or AC.
-
fast 99 replied to the thread 1973 k20 350 intermittent bogging under load.Check fuel pressure and volume. Quite a few bad pumps out there.
-
fast 99 replied to the thread Rear axle seal questions..During disassembly for a leaky axle seal, first check for a loose bearing. Any looseness will decrease the ability to seal. If you're...
-
fast 99 replied to the thread Heavy vibration at highway speed under load.Really sounds like a driveshaft problem, balance, phasing, angles, loose bushing, ect.
-
fast 99 replied to the thread Plug Wire Retainers.I posted pictures in your other thread. Is there a pull and save close to you? Otherwise try searching the Corvette or Camaro forums...
-
fast 99 replied to the thread Spark Plug Wire Holders.Holders for that year have a lock type and I believe were for 8mm wire. They were usually white or gray but like ones pictured below...
-
-
fast 99 replied to the thread Rear axle seal questions..2081 national may fit. Seal can't be inspected during install. That's a problem with a speedy sleeve. It's more likely the outer...
-
fast 99 replied to the thread speeo gear ?.subtract think about it this way, a larger drive pully will spin a smaller pulley faster.
