Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
fast 99's latest activity
fast 99
reacted to
idahovette's post
in the thread
RPM sticking sometimes.
with
Like
.
Choke linkage on the carb, throttle cable binding, look and ye shall find???
Oct 16, 2024
fast 99
replied to the thread
Power Steering Squeel
.
What I ran into [hindsight should have been quite obvious] was the water pump pully had 2 groves the same diameter, crank pully 2 groves...
Oct 16, 2024
fast 99
replied to the thread
Power Steering Squeel
.
Respectfully disagree, had that problem on one of my trucks. Drove me nuts until I figured it out. Water pump pully diameters were not...
Oct 16, 2024
fast 99
replied to the thread
Power Steering Squeel
.
Is there any chance of pully mismatch?
Oct 15, 2024
fast 99
replied to the thread
Best tires
.
Used to be a studded tire fan until I tried a set of Blizzaks for the daily driver. Whatever the tread is made out of works. Michelin...
Oct 15, 2024
fast 99
replied to the thread
Best tires
.
I was a tech at a shop that sold tires. Hankook and BFG were the best tire for the money, casings were round and didn't need as much...
Oct 15, 2024
fast 99
replied to the thread
Idle timing
.
Vacuum advance units can vary from about 10 - 30 degrees. Centrifugal weights, and springs can be much different as well. Usually...
Oct 13, 2024
fast 99
reacted to
Ricko1966's post
in the thread
Idle timing
with
Like
.
And stock Idle speed timing will change as the engine wears and the timing chain stretches. And dependant on the...
Oct 13, 2024
fast 99
replied to the thread
Oil pressure sender switch and coolant sender what type of thread sealant to use since your not supposed to use Teflon so it can ground correctly
.
Liquid teflon never hurts if used in the correct places and not over applied. One thing to point out, in an ideal world those fittings...
Oct 12, 2024
fast 99
replied to the thread
Dual Tanks Fuel switch delete
.
Done on larger [higher] over the road trucks. Our company used low profile trucks. Factory would not install dual tanks like that...
Oct 12, 2024
fast 99
replied to the thread
Finding smog pump 1985 Chevy K20
.
Using early manifolds lower ac bracket is a problem. This truck has those on it when I bought it. They can be made to work but requires...
Oct 11, 2024
fast 99
replied to the thread
HEI module dwell time.
.
Those Sun machines were state of the art and expensive. Cost 8k in the late 70's. An 1115 came up for sale close to me cheap, bought it...
Oct 11, 2024
fast 99
replied to the thread
HEI module dwell time.
.
Basically same as valve float. Inability to control opening and closing. Solving point float sounds easy, increase closing spring...
Oct 11, 2024
fast 99
replied to the thread
Collapsed upper radiator hose
.
Try another cap.
Oct 10, 2024
fast 99
replied to the thread
Collapsed upper radiator hose
.
Assume this has a coolant recovery tank. Yes, a cap can cause it. However, if the overflow tank or hose is plugged that may also do it.
Oct 10, 2024
Latest posts
What have you done to your square lately??
Latest: Ajax19
17 minutes ago
Garage
1
Vapor canister line
Latest: 1987R30
25 minutes ago
Engine & Performance
Recommendations while tearing down for valve job?
Latest: TX87R10
Today at 6:38 PM
Engine & Performance
K
1985 K2500 Build/LS Swap
Latest: K5 Blazer
Today at 6:23 PM
Engine Swaps (Gas) LS, Vortec, LT1 , etc.
Forum statistics
Threads
44,168
Posts
950,804
Members
36,286
Latest member
goodwrenchca
Members
Top