Edelbrock's latest activity
-
Edelbrock replied to the thread C10 LS Swap Actual Cold Air Intake.I used to like them, before I learned more about them through testing. They have their time and place. For example, racing in a... -
I was going to suggest the same thing as edelbrock. Right stuff will be ready to use in 90 minutes. Use the same process as you have for...
-
For me I'm good with any black or gray for use as valley seal in the manifold. But the right stuff is a cut above the regular stuff as...
-
Edelbrock replied to the thread C10 LS Swap Actual Cold Air Intake.From my experience, the K&N type air filters are some of the worst ever made. Although they do have some small performance gains, the...
-
-
Edelbrock replied to the thread How to fix my Front Axle not alligning.You could mark the leaf springs to see if the axle is wandering around. Might want to check the U-bolts to see if they are loose at all.
-
Edelbrock replied to the thread Intake Manifold RTV Dry Times.Hands down the absolute best gasket sealer ever invented. Seals better, dries faster, and lasts forever. I have used it to successfully...
-
-
Edelbrock reacted to nvrenuf's post in the thread What’s the best way to fix/clean up this wiring problem? with
Like.
What are all the extra wires for? If those are all accessories (aka not bypassed factory circuits) then I’d add a secondary fuse/relay... -
Edelbrock reacted to SirRobyn0's post in the thread What’s the best way to fix/clean up this wiring problem? with Like.
Well your going to get some opinions here for sure. Personally I don't mind the marine style battery terminals, though I prefer to get...
-
Edelbrock replied to the thread 87 V10 Wiring.Aside from not knowing where that wire goes, is there any reason to find out where it would go? If there are no symptoms of a problem...
-
Edelbrock replied to the thread What’s the best way to fix/clean up this wiring problem?.Looks pretty clean to me. Are you sure that's not how it came from the factory? ha.. ha... ha... So what ya got here is a wiring job...
-
Edelbrock replied to the thread Missing sway bar bolts. Anyone know what size they are?.Tread specs? Standard I assume? Count?
-
Edelbrock replied to the thread NO power when key is in acc or on position.Fusible link?
-
Edelbrock replied to the thread Rebuilding rear axle DIY?.From my limited understanding, you have to know EXACTLY how to do it. Any mistakes at all are not tolerable. There are enough important...
-
Edelbrock replied to the thread Factory tach wire hole in firwall.Well, that's up to you. I generally look for an exhausting hole that was put there by the factory to feed wires or linkages through the...
