Doppleganger's latest activity
-
Doppleganger reacted to Drauka99's post in the thread Filling small holes without welding with
Like.
Agreed on the welding for the small holes. If its rusty then it might blow out to a bigger area and have to stack in a bit more weld to... -
SOLD
-
Doppleganger replied to the thread Filling small holes without welding.A friend of mine came by about a year ago - he'd been welding 40+yrs - and couldn't stop from turning small holes into bigger ones on...
-
Doppleganger reacted to legopnuematic's post in the thread Filling small holes without welding with Like.
Use some copper or aluminum to back the area up, works as a heat sink and helps with bridging a gap. Larger holes a Whitney Jensen hand...
-
Doppleganger reacted to Ricko1966's post in the thread Filling small holes without welding with Like.
If you've got an oxy acetylene outfit I'd braze them shut.
-
Doppleganger reacted to SquareRoot's post in the thread Filling small holes without welding with Like.
My buddy asked me if I could weld up some 3/16 holes in the trunk of his 69 442 this weekend. I have a 120V mig welder that I use 99% of...
-
Doppleganger replied to the thread Filling small holes without welding.Dare I ask?
-
Doppleganger reacted to Robert Bare's post in the thread Filling small holes without welding with Like.
Sand the bondo too much, and it and the paint covering it will fall out. Welding is preferable, lead is the old way, yet still widely...
-
Doppleganger replied to the thread Filling small holes without welding.I know the few articles I've seen on it, they always say to avoid the acid core. I've always had questions about the flux issue - would...
-
Doppleganger reacted to legopnuematic's post in the thread Filling small holes without welding with Like.
I have not done the soldering method, but have used JB weld to fill over a hole or two and have had reasonable success. Short strand...
-
I have read in the past that you can fill small holes (like trim deleting) with solder and not have to mess with welding. Anyone done...
-
Doppleganger reacted to Craig 85's post in the thread Vintage Air Gen V (5) or replace existing compressor, etc., for 1987 R20 Suburban? with Like.
@beady when I added my fan I found out the ‘85 OEM style sensor was discontinued. I used one for a GMT -400. Look around page 13-15 of...
-
Doppleganger reacted to Craig 85's post in the thread Vintage Air Gen V (5) or replace existing compressor, etc., for 1987 R20 Suburban? with Like.
I actually added it. All my other 454 trucks had it. This truck didn’t have the Z82 tow package which included the aux fan. It was easy...
-
Doppleganger reacted to Goldie Driver's post in the thread Vintage Air Gen V (5) or replace existing compressor, etc., for 1987 R20 Suburban? with Like.
Other than flushing watermelon :dogpile: I think he mentioned it's only use.
-
Doppleganger reacted to Craig 85's post in the thread Vintage Air Gen V (5) or replace existing compressor, etc., for 1987 R20 Suburban? with Like.
I had an aftermarket in dash A/C installed years ago on my '80 crew cab. Vents were in the OEM dash locations and used the factory...
