Dleslie212's latest activity
-
DDleslie212 replied to the thread Sad Discovery: GM 10 Bolt Fails.FWIW, I completely rebuild my 12 bolt a few years back, only reused the housing itself. It took me a long long time. Probably a month...
-
DDleslie212 reacted to kkgp81's post in the thread Dakota Digital install with American Autowire harness- ETA adding TCI 4L60E control to the install with
Like.
Was mostly busy yesterday and today but found a little time. Had to change the connector for the trans output speed. Starting... -
DDleslie212 replied to the thread Lower Steering Shaft Bearing.https://www.amazon.com/dp/B008VQ003M/
-
DDleslie212 replied to the thread Dakota Digital install with American Autowire harness- ETA adding TCI 4L60E control to the install.Looking great!
-
DDleslie212 replied to the thread Opinions on grounds needed.My socket grounds, both up front and in back, tie together and connect to the nearest grounding lug with a ring terminal
-
DDleslie212 replied to the thread Opinions on grounds needed.I ended up going the daisy chain method. People here told me it was overkill, but I don't care I drilled holes in various locations...
-
DDleslie212 replied to the thread 76 K10 rear main seal.Is it a decent idea to just change all the rod bearings while the pan is down?
-
DDleslie212 replied to the thread 78 K-10 Dual Tank Install.It had the old three port valve, with single power wire. I replaced it with the newer six port version, and when you do that, you have...
-
DDleslie212 replied to the thread Wiring Harness journal.Dome light fixture and socket replaced and working. Pass side jamb switch working, drivers is not. It's brand new but luckily cheap.
-
DDleslie212 replied to the thread Making the Fuel System Simple.FWIW - I installed an online pump with my Pro Flo 4 system originally. Stupidly, my first test drive was on an offroad trail in the...
-
DDleslie212 replied to the thread Fuel Tank Replacement.You don't have to get a new sending unit if yours is working, but I probably would. Replacing those is not fun, and you're going to have...
-
DDleslie212 replied to the thread Replace Steel Dash.I actually saw the three dashes in the LMC magazine yesterday, which is what got me asking this question My dash is pretty mangled...
-
DDleslie212 replied to the thread Replace Steel Dash.How long would you say that took? And how hard to get lined back up properly?
-
DDleslie212 replied to the thread Replace Steel Dash.Old thread I know. Has anyone done this recently? I'm curious how difficult it would be to replace mine
-
DDleslie212 replied to the thread 78 K-10 Dual Tank Install.I had the same thing happen with my 77 K10 a few years back. I was replacing the fule hoses, and I snapped the barbed end off the...
