Craig Nedrow's latest activity
-
Wow 300 bucks is a steal! Welcome from Texas nice looking truck. -
Welcome from Washington! That looks to be a great project! Nice find!
-
Oh by the way, gave him the tidy sum of $300 for it! and the only rust is surface on the roof.
-
Hello all! Just lucked onto a great project, a 91 last year suburban! It doesn’t run, but is very solid and all there! I plan on working...
-
Craig Nedrow replied to the thread BBC 489 build.Sooooo, dang two steps forward and one step back. Have to wait to set my cam up. Also got this in today from repair, this will go in the...
-
-
Craig Nedrow replied to the thread BBC 489 build.Monday and a little done. Howards timing set had to be returned, as it was just to tight, like no slop at all, tight. Summit was very...
-
-
I've used my 3D printer for quite a few "practical" things, I think most or all of those have ended up being a rapid prototype part to...
-
What does your air cleaner look like? This is what the TBI 87s I’ve been around look like:
-
You should seriously consider some Hookers at this point ;) 10X better than the OEM style. Better in every way.
-
I cut off the material below flange on the manifolds of my K5 to have a flat sealing surface. I used a fat flange with a flat gasket...
-
These are what I’m ordering
-
She’s a beaut! Welcome from Wisco!
-
Hi everyone! I’m new here. I have have a 82 K5 with a 454 6” lift on 35s I just bought this truck and looking for advice on all my...
-
Hm, the position would match with the side trim. Maybe the original trim was adhesive and retainers at the ends that were prone to get...
-
Craig Nedrow replied to the thread Harbor Freight Table and carts.Ha, Hey Andy spent the first twenty on gravel with a piece of plywood, I don't forget what it was like, and am so grateful for my shop.
