Craig Nedrow's latest activity
-
How should I tell the difference? In my '85 truck there is a smaller metal line right below the fuel line and it was not connected to... -
The return setup would be preferred with today’s lousy gas. The 3 port pumps have a tiny orifice in the return fitting, basically a...
-
Are you sure you have a fuel return line,and you aren't looking at a vent line. If you have a return a 3 port pump with return would be...
-
Craig Nedrow reacted to ali_c20's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with
Like.
When I did the swap 203 to 205 on my K5 I had to have the front driveshaft shortened and the rear lengthened. I have a TH350 and GM... -
Craig Nedrow reacted to Strick's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
Is it a Dana 60 truck? I know that doubling the cases makes for the length difference but I've never had to replace the front driveshaft...
-
Craig Nedrow reacted to DonN's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
No it's not. The 203 shaft is longer. I just put a twin stick 205 behind a TH350 in my K10 and had to have the front shaft shortened and...
-
Craig Nedrow reacted to Ricko1966's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
You should have capitalized underlined and quoted" I AM NOT CHANGING TRANSFER CASES" You'll know better next time.
-
Craig Nedrow reacted to Strick's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
The front shaft should be the same length for an NP205 or NP203. The rear shaft will be shorter on an NP203 because the case length is...
-
Craig Nedrow reacted to Bowtie-dad's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
This is a double cardan 1350 drive shaft from a 1ton with a 205 t case and Dana 60 front diff Tom woods can build a custom one to fit...
-
3.73 should be 41 on the ring, 11 on the pinion (ie 11:41 or 41:11 as stamped in the gear). K
-
Have the person you are talking to count the teeth on both gears. And or get us ALLL the numbers off the ring and pinion. Normal there...
-
Count the number of teeth on the ring gear and divide by the number on the pinion. That's the ratio. K
-
Craig Nedrow reacted to Snoots's post in the thread No crank. No power at all 1885gmc 2500 with Like.
WTF!? was the problem?
-
Craig Nedrow reacted to YakkoWarner's post in the thread No crank. No power at all 1885gmc 2500 with Like.
If you have no power anywhere, I'd start with the basics - put a meter on your battery and make sure you have power (yes I know you ran...
-
Hello all, While in "paint jail" paint shop lost the complete wiper motor ASSY including linkage from my 1974 C10 ! What fits ? I found...
