Craig Nedrow's latest activity
-
Craig Nedrow reacted to HotWheelsBurban's post in the thread Mar-K Truck Toolbox for Stepside with
Like.
I like it too....but a good fabricator could build a box with a truck tailgate for that $$$. I'm not a good fabricator but neither am I... -
I have one like this for my C30 but it is big enough to climb inside and takes a lot of space. I'd like to mount a smaller version that...
-
I have a Reading saddle box. Any longer wood or stock can slide under it.
-
Craig Nedrow reacted to TotalyHucked's post in the thread Mar-K Truck Toolbox for Stepside with Like.
Yikes, that's some coin. I've got a Tractor Supply box in my fleetside and am very happy with it. Sits just below the bedrails, I...
-
Craig Nedrow reacted to squaredeal91's post in the thread Mar-K Truck Toolbox for Stepside with Like.
I'd buy one if I could afford it lol. I love it
-
Nice to meet you also.
-
Does anyone have the Mar-K stepside tool chest? They are expensive but I can’t find a single picture of one in the truck. Other then...
-
Craig Nedrow replied to the thread Lifter tick?.When I first read this, I was thinking of Tommy Chong on Up in smoke....glad you clarified that. Not that there's anything wrong with...
-
Not critical to your issue/question at hand, but your valve cover spreader bars are on upside down.
-
Adjust the valves while you have the covers off. Use the two-roll method.
-
If it’ll slide, yes. Sometimes, they don’t wanna slide and get stuck
-
So if you pop the clips front and rear will the trim slide off the stick on clips or does the sticky foam need to be cut? Like with...
-
Here's the relief in the trim I was talking about for the clips It's in between those two clips, about a foot from the rear of the...
-
Didn't get up to the shop till nearly 2pm yesterday cuz I was junkyarding and the guy I was gonna ask was gone. But I axed him today and...
-
The square pads with the 3M tape are able to slide within the trim. That's why you'll commonly see a truck with several screws in the...
