Craig Nedrow's latest activity
-
Craig Nedrow reacted to bluex's post in the thread Nv3500 into an 86 k10, but not a normal swap. with
Like.
This also should have only required a pressure plate change to the older 95 an down style. The bellhousing is different because of the... -
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Ah interesting. I was wondering. I just recently replaced the NV4500 in my 98 with one from a 95. I figured one for one swap, be...
-
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
I gotcha.. I have the orginal 11inch clutch and pressure plate off my 305. I should bolt them up to a flywheel and put them in the...
-
Craig Nedrow reacted to Ricko1966's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
^^^^ use the pressure plate that matches your engine and a clutch disc that matches your transmission,may have to look at a few to pic...
-
Craig Nedrow reacted to bucket's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Glad to hear from you again! Are you sure you're engine is an '86? '86 was the first year for a 1-piece rear main seal with the smaller...
-
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Thanks. Im still alive, just alot going on. Haven't been real active here, but still try to check in now and then. Still working on my...
-
Craig Nedrow reacted to AyWoSch Motors's post in the thread Nv3500 into an 86 k10, but not a normal swap. with Like.
Okay i have kind of an odd situation. Looking to swap a NV3500 into my 86. Found alot of threads here, but no one has my exact...
-
Look at your driveline mounts for wear/play. These engines move all over the under load. Your chattering might be due to the springs in...
-
So I pulled the driveshaft and brought it to the driveshaft shop. It was a little out of balance, but they said due to the long length...
-
Thanks for the information on this. I'll look into it. It's not really chirping but I feel it a little in a slow turn pulling on to the...
-
No, you're thinking of a locker where the axles *always* spin the same. A locker keeps the two wheels locked together at all times and...
-
Before you go rebuilding the posi, if it still does it after the 'shaft gets rebalanced, pull the shaft out and rotate it 180* and try...
-
Yes they are good. Before I re-rebuilt the truck, I was using this transmission and this rear end with no issues. I think new clutches...
-
Probably not necessary to comment but if the driveshaft is suspect did you check that the transmission yoke and pinion angles are equal...
-
That is not a GM limited slip differential. The GM govern lock differential does not require posi additive. That locker may require...
