Craig Nedrow's latest activity
-
-
Craig Nedrow reacted to Bloodhound1981's post in the thread Have you checked your ground? with
Like.
Similar to my first response when I get computer and IT questions at work. Someone eventually bought me this shirt since I say it so much, -
A faulty ground was my problem on my dual tank setup.
-
I used to ask questions of the electrical Vehicle System Engineer all the time. I had him on speed dial from the back barn to his...
-
That black wire is most likely a fusible link to protect the trucks main circuits. The main bulkhead connector has 2 main power wires...
-
I believe that pink one is the fuel tank level sensor wire. It snaps onto a port on the sending unit on top of the tank.
-
Craig Nedrow replied to the thread What aftermarket engine harness?.I have used American Autowire harnesses in two builds, and they are very good, you can buy what you think you need, go Here, good info...
-
Craig Nedrow reacted to Turbo4whl's post in the thread Project is stalled. Cannot solve brake problem with Love.
If the rear brakes shoes are not adjusted out to the drums, then you will have trouble bleeding the rear cylinders. Remember the (self)...
-
Craig Nedrow replied to the thread 350 bearings questions.With the pan off like you have it, position any easier to get to rod at 90 degrees, unbolt cap and pull it off. install 3/8 hose on rod...
-
Platigage won't tell you if the bearings are standard .010 etc. It will tell you if clearances are correct. When you resize a rod or...
-
Craig Nedrow reacted to dr_diesel's post in the thread Dakota Digital RTX Install Critique with Like.
Thanks for all the info working on an 82 C20 and think I might go with the VHX model as it is a straight six with 3 speed. Just little...
-
Craig Nedrow reacted to TotalyHucked's post in the thread Dakota Digital RTX Install Critique with Like.
Yeah I've had my Squarebody Syndicate versions for 3 years and nearly 40k miles now, these are by far the best gauges on the market...
-
Craig Nedrow reacted to PrairieDrifter's post in the thread Dakota Digital RTX Install Critique with Like.
I am also not an instructions guy. But the ones included were very informational and easy to follow if you're savvy, don't need to be a...
-
This was great information, thank you for the write up. I want one but waiting until I get to the point where I need it for the next step. .
-
The DD clusters are good. I’m in the middle of one using the DD setup, 4L60e trans controller and American Autowire harness. One thing...
