Craig Nedrow's latest activity
-
Craig Nedrow reacted to SquareRoot's post in the thread Dakota Digital RTX Install Critique with
Like.
Yup. Been enjoying mine for several years now. I use it with Edelbrock PF-4 efi and the amount of data displayed is amazing. I love... -
Just installed a Dakota Digital RTX instrument cluster in my '81 C10 and wanted to throw out a couple opinions and comments. I picked...
-
Craig Nedrow reacted to Camar068's post in the thread Project is stalled. Cannot solve brake problem with Like.
I like the gravity method. Master cylinder cap off, open the bleeder to get some flow. Then tap on components (screwdriver, wrench...
-
Craig Nedrow reacted to jh86's post in the thread Project is stalled. Cannot solve brake problem with Like.
Just reread your post. I was also getting low flow out of rear until I really opened up the bleed screws. Solved my bleeding problem
-
Craig Nedrow reacted to jh86's post in the thread Project is stalled. Cannot solve brake problem with Like.
Did you bench bleed the master cylinder? I just did the entire brake system on my 86 a couple months ago with almost identical part...
-
Thermostat *is NOT* upside down. Vehicle was driven 50 miles after running in my driveway for an hour.
-
Craig Nedrow reacted to Chris64's post in the thread First real drive! Not tragic but not good. I think I need carb advice. with Like.
OK - I found this cheapo bracket on Amazon. It needed a tiny bit of modification but seems to work ok. I may end up making a...
-
Craig Nedrow replied to the thread Project is stalled. Cannot solve brake problem.Is this vacuum canister, or upgraded to Hydra-boost. If vacuum canister, is the diaphragm good? You have plenty of vacuum for a...
-
Craig Nedrow replied to the thread Cab repair stabilizing.Did this on my 64 Nova, basically removed the whole back half of the car. My body shop buddy told me to weld braces in the body to the...
-
This is as much as I cut before starting this thread.
-
It probably fell out of the cab corner area like a bunch of other junk when you go to removing the rotten metal...
-
I saw a tool once that clamped on the striker and bolted to the door hinge holes in the cab. Same outcome, keep it straight. Eric
-
I figure that’s about as good of a place as any for a 305 crank :gr_grin:
Latest posts
-
-
Gas to Diesel swap, question on fueling- Latest: AuroraGirl
-
-