Craig Nedrow's latest activity
-
This is as much as I cut before starting this thread. -
It probably fell out of the cab corner area like a bunch of other junk when you go to removing the rotten metal...
-
I saw a tool once that clamped on the striker and bolted to the door hinge holes in the cab. Same outcome, keep it straight. Eric
-
I figure that’s about as good of a place as any for a 305 crank :gr_grin:
-
On my 79, the outer rockers while rusty, were still structurally sound, I cut out the remainder of the floor and inner rockers and kick...
-
This is what I made for my K5 body...used thick walled square tubing.
-
That's a dam good idea,I never thought of it and never had a problem,but if a person welded angle across both door openings and then...
-
And if you are cutting out a lot on either side, like rockers, floor pans and cab supports, it wouldn't hurt to weld in a length of...
-
When I cut out major sections like rockers etc. I weld angle iron across the inside of the door opening as low as I can and still be...
-
Craig Nedrow replied to the thread BBC 489 build.each day, lil' closer. Installed freeze plugs, using Permatex #1 brown form-a-gasket, rated for this application. Also installed all the...
-
-
-
Craig Nedrow replied to the thread BBC 489 build.Here it the Cloyes timing cover, has roller button to control cam walk, and is easily adjustable. Will need to buy/make a timing...
-
-
Miles, maintenance history, what repairs have been done that won’t need to be done again soon and condition are the best ways to judge...
-
The problem area with these trucks are the front wheel bearings, the front cover seal, the head gaskets if it's an iron block with...
-
I believe the 2005 was the last year or next to last year that did NOT come with DOD. I'd drive the hell out of that truck. Powertrains...
