Craig Nedrow's latest activity
-
Craig Nedrow reacted to Mark Jones's post in the thread My Rear End Build For My Low Buck Street/Race Truck with
Like.
New best: 1.50 60 foot 7.04 660 94.19 MPH 660 -
Craig Nedrow reacted to Mark Jones's post in the thread My Rear End Build For My Low Buck Street/Race Truck with Like.
NEW BEST 7.63 1/8 mile 87 MPH 1/8 mile 1.62 60 foot 2000 feet DA 29.40 Barometer
-
Craig Nedrow reacted to HotRodPC's post in the thread My Rear End Build For My Low Buck Street/Race Truck with Like.
This the kinda $hit you gotta be careful of in OK. No need to worry about the rich fan boy Coyote Mustangs and Camaros and Vettes...
-
Craig Nedrow reacted to Strick's post in the thread What have you done to your square lately?? with Like.
Took the farm mule & got me some brakes again. Dear ole dad left me some "tropical blue" & I bombed the Spring Green/Frost fender. I...
-
Craig Nedrow reacted to mxer147's post in the thread What have you done to your square lately?? with Like.
Sprayed bed liner, shoot white tomorrow.
-
Craig Nedrow reacted to Chevrolado's post in the thread What have you done to your square lately?? with Like.
Pulled out the dash to get working on some wiring cleanup and organization.. :)
-
Craig Nedrow reacted to idahovette's post in the thread What have you done to your square lately?? with Like.
^^^^^^^^^YES Lucky you....GOOD times with MOM!!!!!!^^^^^^^^
-
Craig Nedrow reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Since the knee has me somewhat sidelined, took my mom out for lunch and finally got that damn good chocolate malt I’ve been after...
-
Back to the radiator The custom size outlet came in, cut the hole in the tank some Tig welding will have that job done ...
-
Another item been added to the 'Kool' factor ... ! .... GOT WOOD .... !
-
Found the seal ... Took a month, came in today ...
-
Cured the leak, power steering pump pulley came in .. Mounted the pump and tried my best to get the belts to track right ... After a...
-
Waiting for the 1-5/8" bung to show up, welding will go down when all the ducks are in a row .. Water pump double belt pulley came in...
-
I do have a concern bout the compressor having room without getting into the inner fender ? Was going to shoot the engine bay sheet...
-
It's aluminum .. 4 row, installed a two speed puller fan ... The radiator has a trans cooler built in .. My plan is to run a remote...
Latest posts
-
-
-
FB Marketplace find near Austin, Texas: 5 aluminum K10 wheels $50- Latest: Johnny Atomic
-
-