CountKrunk's latest activity
-
CCountKrunk reacted to WFarm's post in the thread What have you done to your square lately?? with
Like.
Had a couple custom T-Shirts made on Etsy to wear at shows and Cruise Ins. Pretty reasonable, design was like $8 and shirts were $16... -
CCountKrunk reacted to Mr Clean's post in the thread What have you done to your square lately?? with Like.
Gutted the Mistress today. Tried not to rip and tear the wiring out. Then it became a moot point after I saw how bad the rats or mice...
-
CSo when does one of these make it’s way into the plot? :)
-
CWell ... Here we go .. Looks like I'll be sleeving this hole .. I'm eyeball to eyeball with a crack ..
-
CI'm not really sweating those too bad. The rear two already have the heads busted off but have a good bit of the bolt left sticking out...
-
COur '76 shop truck is believed to be Yuba Gold
-
CMazel Tov!!! It's a boy!!! Lol
-
CWhat kind nonsense is this? It's out, put the cam in it!?!?!?!!??!!!!!!!
-
CSo now it’s time to get it on the stand, throw the plugs back in, tape off the ports and pressure wash and de-gunk it. Then I’ll...
-
CSo then I had to work it all the way back down onto its mounts, decouple the hoist, pull the fans out and try again And finally, it’s...
-
CDidn’t work on it Monday, but I did last night. Started by undoing the wiring under the oil pan and bungee’ing the PS/Atl bracket out of...
-
CSome pics
-
CI guess the innards of my trans dont look that bad...just a few small chips on some gears. When I pulled the tailshaft off to change the...
-
CCountKrunk reacted to legopnuematic's post in the thread Homemade and modified tool thread with Like.
Cab lifting beam for use with cherry picker Cardboard laid out to mark mandrel bends to cut them correctly. Also 3d printed mandrel...
