ChuckN's latest activity
-
Bullbar update cut and bent the new brackets made some rubber washers from some old truck tires to go in-between the bullbar and the... -
ChuckN replied to the thread What have you done to your square lately??.That’s a great response, I’ll give that a try. A looser converter is on the list as well.
-
ChuckN reacted to Rustisbest's post in the thread What have you done to your square lately?? with
Like.
I would experiment with 3 degrees more and see how it drives when weather clears. It should raise the idle speed and allow you to close... -
Measurements so far won't know the bar length until I get the brackets on the truck
-
ChuckN replied to the thread What have you done to your square lately??.The stall is too tight and stock. That’s for sure. Three degrees? Which direction? I called Edelbrock and they told me to put it back...
-
ChuckN reacted to Rustisbest's post in the thread What have you done to your square lately?? with Like.
Will it rev clean in park/neutral? What converter and trans? Just my opinion but you're missing 3 or more degrees of timing with those...
-
ChuckN reacted to Rustisbest's post in the thread K5 K10 17x8 or 17x9 vision Cheyenne Aluminum rally wheels? with Like.
17x8 . Not my truck pic is from here https://67-72chevytrucks.com/vboard/showthread.php?t=854710
-
If style with a hose on it remove the end piece. Any exhaust leak will be quite noticeable as air passes by the end of the open hose.
-
But to the question at hand, check valves as @DoubleDingo shows, also note if any are loose, loose. Check your header bolt tightness...
-
That's not quite accurate. Most axle flip kits have the pinion angle correction built into it so the end user doesn't have to worry...
-
Nobody at all repops them at this point and it's very rare to find a decent used one. We just snagged one off eBay to start development...
-
ChuckN replied to the thread What have you done to your square lately??.True that- but then I got to thinking, a cam is much more than lift- it’s also duration, duration at .050, and just as importantly...
-
ChuckN reacted to legopnuematic's post in the thread What have you done to your square lately?? with Like.
If you remove the rocker from the equation, thus removing the valve spring and set your indicator on the pushrod itself, or use...
-
ChuckN reacted to TotalyHucked's post in the thread What have you done to your square lately?? with Like.
Oooo, good point. That I'm not sure of. Maybe if you knew what lifters you had, you could use those specs but without knowing what...
-
Here's a couple good videos from my buddy, Jason
