ChuckN's latest activity
-
Here's a couple good videos from my buddy, Jason -
ChuckN replied to the thread What have you done to your square lately??.If it’s a hydraulic tappet, is there a way to account for the “squish” of the lifter? I’ll check that out.
-
ChuckN reacted to TotalyHucked's post in the thread What have you done to your square lately?? with
Like.
I have never done it so take this with a grain of salt, but I've seen several videos (youtube and on whatever PowerBlock is called these... -
Thanks for the replies. I ended using the gantry had enough height to clear the front end so I could roll the frame out and the mount...
-
ChuckN reacted to legopnuematic's post in the thread What have you done to your square lately?? with Like.
What CFM carb is on your truck? Engine specs? Heads, cam, intake, etc? Base timing? Are you using a vacuum gauge along with the...
-
ChuckN replied to the thread What have you done to your square lately??.Hey, well, maybe you can shed some light. 355 SBC, about 10:1. Cam unknown, runs about 15-16 mmHg at 750 rpm. Timing is set to 35 total...
-
ChuckN replied to the thread What have you done to your square lately??.@Redfish think I’ll spray around and double check for vacuum leaks, but it seems unlikely that the one spot it runs lean and everything...
-
ChuckN reacted to Redfish's post in the thread What have you done to your square lately?? with Like.
How perfect does it need to be? Would you actually know it wasn't right if you did not have that new monitoring system in place? I...
-
ChuckN replied to the thread What have you done to your square lately??.Well, it’s “not-perfect “ enough that it falls on it’s face until the power mode finally catches up with it.
-
ChuckN replied to the thread What have you done to your square lately??.Sounds nice and mellow.
-
ChuckN reacted to Soundmound's post in the thread What have you done to your square lately?? with Like.
She's breathing now. 3" from the Y back through a Magnaflow 12259 and dumps out the stock location. Literally all I got to hear it...
-
ChuckN replied to the thread What have you done to your square lately??.It’s true- the vents seem to let a lot of gas evaporation.
-
What I love about Carter/Edelbrock carbs: bolt on & drive them‐where ever you want. What I hate: spinning over of the engine after...
-
ChuckN reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
Yep. Makes sense.
-
ChuckN replied to the thread What have you done to your square lately??.Yeah, no power valve on an Edelbrock that I’m aware of.
