Chris64's latest activity
-
Mine has 4" Skyjacker C140S softride front springs, ORD HD front greasable shackles, 4" lift blocks in the rear with factory springs... -
Chris64 reacted to bruisedbanana79's post in the thread Wanting 4" suspension suggestions with
Like.
I will add that I ordered a 4" kit directly from Tuff around black friday and was told it would ship 1/6. I finally cancelled my order... -
Cheap would be Tuff Country EZ Ride. My experience with these is that they do ride pretty decent for off the shelf. I’d plan to buy...
-
Chris64 replied to the thread Wanting 4" suspension suggestions.They're 35x10.5 BFG AT on 10" wide wheels with a -22 offset - so they're wide-ish. Wouldn't moving the axle forward an inch require...
-
I have used that 1" zero rate spring before and thought it was cheap and easy PLUS! it raised one inch. *(rear only) Hope this helps...
-
Potential fitment issues with the 35s depend a lot on wheel choice (width and offset/backspacing) and tire choice, if it is a true 35”...
-
Chris64 reacted to mcarlo86's post in the thread What have you done to your square lately?? with Like.
Sweet wheels!
-
Chris64 replied to the thread Wanting 4" suspension suggestions.How big of an effort is that? I'd probably need a longer drive shaft and the pitman arm, correct? I like this idea in spirit.
-
For leaf springs you could get ORD Custom, which are produced by Alcan. Double check all the measurements from main eye to centering...
-
My 77 original 1 tank with aftermarket 2nd tank has a 1 wire switching valve and works flawlessly. Seems far less complicated than the...
-
I have to empty one of the tanks full of old fuel and inspect it. Now you got me thinking maybe I should run them both. I was just going...
-
My K-20 currently has a 2" lift. It came that way. I assume it's aftermarket leaf's up front and it has 2" blocks in the back (I looks...
-
Chris64 reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Fought the old bolts for a bit then test fit one side still gotta drill the holes in the bumper to 5/8" but I'm liking the look so far
-
Chris64 replied to the thread What have you done to your square lately??.Oh let's see... * Finally got my timing about right. * It finally starts and runs great...and... * Starter stopped working - tapped it...
-
-
