Chris64's latest activity
-
Chris64 replied to the thread Wanting 4" suspension suggestions.How big of an effort is that? I'd probably need a longer drive shaft and the pitman arm, correct? I like this idea in spirit. -
For leaf springs you could get ORD Custom, which are produced by Alcan. Double check all the measurements from main eye to centering...
-
My 77 original 1 tank with aftermarket 2nd tank has a 1 wire switching valve and works flawlessly. Seems far less complicated than the...
-
I have to empty one of the tanks full of old fuel and inspect it. Now you got me thinking maybe I should run them both. I was just going...
-
My K-20 currently has a 2" lift. It came that way. I assume it's aftermarket leaf's up front and it has 2" blocks in the back (I looks...
-
Chris64 reacted to Ajax19's post in the thread What have you done to your square lately?? with
Like.
Fought the old bolts for a bit then test fit one side still gotta drill the holes in the bumper to 5/8" but I'm liking the look so far -
Chris64 replied to the thread What have you done to your square lately??.Oh let's see... * Finally got my timing about right. * It finally starts and runs great...and... * Starter stopped working - tapped it...
-
-
-
Chris64 replied to the thread LMC AC controller has too many detents.Well LMC did follow up with me but not with the news I wanted to hear. They said that this part is correct and nobody's complained about...
-
Threaded rivets are ok. Don't use stainless as the sheet metal that is contact with them will rust very quick ( galvanic corrosion). Use...
-
Chris64 replied to the thread LMC AC controller has too many detents.That's good info - thank you. I was wondering about that left detent on the cold. Now I know.
-
The dash controller has to match the large vacuum switch bolted on the back (it’s visible in the photo of the newer switch). You...
-
Chris64 replied to the thread LMC AC controller has too many detents.You know - I didn't even consider this because most online places don't give any service. I called them and they were very helpful. They...
-
Chris64 reacted to projo198's post in the thread Any explicit help on removing AC components and keeping heat? with Like.
I ordered it on Amazon, but on a whim today I went to a junkyard and found a donor truck with EVERYTHING I need.... It was almost intact...
-
Chris64 replied to the thread LMC AC controller has too many detents.This is what I have So six positions. The stock one for sure only detents on those 6 positions. The LMC just has this exact same...
-
