Chris64's latest activity
-
I ended up using 2 small utility hinges and low-profile screwheads going through the original plastic on both sides of where it fatigued... -
I replaced mine with a strip of harness leather. Been on there for 9 years now.
-
I used 3M Glass Cloth tape on mine because we have a ton of it here at work. 2 years in and no issues so far. It is white though so it's...
-
Chris64 replied to the thread Rebuilding my dash pad..I may go that route. We'll see. Contact cement is slowing down my progress greatly. Here's the first layer of EVA foam to level out...
-
-
Was thinking of redoing mine myself, but decided to go with this one. Took a couple of hours and putting it in and out half a dozen...
-
Chris64 replied to the thread Rebuilding my dash pad..Productive day. Stripping off the original dash is not fun. Heat is your friend. Managed to get it down to mostly shiny...
-
-
Chris64 replied to the thread Rebuilding my dash pad..This is more complicated than anything I've done but I figure what's the risk. Vinyl stretches pretty good with a heat gun. Hopefully...
-
This is a long video but this guy is a true pro and makes an art look easy. I thought if I could get mine to look 40% as good as his I...
-
Have seen some nice dash pad rebuilds. If you’ve done upholstery work should be not too difficult for you. Common theme is the nicest...
-
I took mine to an upholstery shop because it had been covered before. Here's copy of a thread of my build, showing the speaker hole...
-
It's just foam. The center opening was only for the speaker, so it won't hurt anything at all if you choose to cover that area.
-
From my research, stock hoses Should be long enough with a 2 inch lift but I've been thinking about replacing them with longer hoses...
-
Chris64 replied to the thread Front end noise.Well, the e-brake cable is just the rear-end probably (I re-read the title). But also the actual brake rubber hoses may need to be...
-
Chris64 replied to the thread Front end noise.I have a 2 inch on my K20. Is the e-brake cable clear? Mine is really close to the rear driveshaft and the exhaust. Yet another project...
-
OK, A new project that probably won't work, but I'll try. I figure worse case scenario, I just buy a whole new dash. My original plan...
-
