carnutjw's latest activity
-
Ccarnutjw reacted to idahovette's post in the thread Twitchy steering with a big travel trailer (rear sway bar help?) with
Like.
Could be tire squirm....Don't think those tires are stout enough for the load?? -
Ccarnutjw reacted to HotWheelsBurban's post in the thread Twitchy steering with a big travel trailer (rear sway bar help?) with Like.
Do you have a weight distributing hitch on the trailer with sway control? On a trailer that long I'd definitely recommend it if you...
-
CMineral spirits maybe? I use it to get paint off my hands...
-
CIn my Dart, 71 225/auto
-
Ccarnutjw replied to the thread Let’s see your memorabilia?!.Picked up another useless trinket today: 18"x24" , beat up, overspray, but looks okay in photos. Looks like house paint overspray on...
-
-
CThere is an upholstery shop there. The attached image has the phone number. Give 'em a call...
-
CPossibly just snapped the parking pawl.
-
Ccarnutjw reacted to Mr Clean's post in the thread Scores from DIY Parts Yards, Pull A Part, U Pull It etc with Like.
I had to take a train out past the yard. The tracks run behind a salvage yard. As I was rolling by, I spotted a Suburban with the air...
-
Ccarnutjw reacted to legopnuematic's post in the thread Bolt hole pattern on the front of the heads with Like.
All small block heads with accessory holes should be the same pattern, late 60s to vortec era. The 1986 and older is likely from being...
-
CSoooo, while she looks a little rough, I just have one little bit of rust at the rear window, and body work is done. I will use 3M seam...
-
Ccarnutjw replied to the thread Tire/wheel recommendations.I know this has been shared on the forum previously, but I really think it helps visualize what's going on with different...
-
CThe specific carburetor number is on the side of the carburetor - for your 80's truck it would be something like 17080213. Then go to a...
-
COk I think it's a combination of me not conveyed my thoughts good enough, as well as the fact that anywhere I've ever looked for wheels...
-
CThe problem with having only the offset, is that you have to assume the extra 1/2" (or so) of flange width because an 8" wheel is...
