Camar068's latest activity
-
Camar068 reacted to squaredeal91's post in the thread 700r4/NP208 wont shift into 4lo or out of neutral with
Like.
Sounds like you're trying it right by putting trans in neutral. Does your truck idle high? Maybe it's got too much kinetic energy... -
Camar068 replied to the thread 700r4/NP208 wont shift into 4lo or out of neutral.lol again....thought the truck had to not be moving. If not disregard lol.
-
Camar068 replied to the thread 700r4/NP208 wont shift into 4lo or out of neutral.not knowing the intricates of the NP208, but my thought with old school vehicles you don't shift the transfer case while moving. That's...
-
Camar068 replied to the thread Engine Crossmember Replacement.ORD is an option link in green [edit] sorry thats for 4x4, link below may be for 2wd but with extra parts you may not need. If...
-
Camar068 replied to the thread What have you done to your square lately??.look at mastercraft next round.
-
Camar068 replied to the thread What new tools have you got lately?.I don't judge anyone for FB. There are honest peeps out there. If you feel they are right through conversation, go for it. Higher...
-
Camar068 replied to the thread What have you done to your square lately??.if I remember right, someone posted one the was higher than that recently around $120. I'll dig if necessary.
-
Camar068 reacted to 1976dully's post in the thread What have you done to your square lately?? with Like.
Finally got our LS swapped 76 driving last night. New tank, sender, lines, filter/regulator, pump, plugs and wires. Terrorized the...
-
Camar068 replied to the thread What new tools have you got lately?.if it's not getting soaked, dielectric grease may do the trick. Another source if your connector isn't in the amazon kit, mouser will...
-
Camar068 replied to the thread Batteries sho.is there anything you did just prior to the issue? Install new radio, security system, etc. I'd also check your ground cables from...
-
I bought these Doyle wire cutters from Harbor Freight and they are excellent. They are sharp and cut through all the different wires...
-
Camar068 replied to the thread Fluid Changes.catching up, first thing I thought was....."and I gave this guy a $h|7 load of parts....wth". lol
-
Camar068 replied to the thread What have you done to your square lately??.Ran wiring for the winch. Probably make a "Y" to run a pump to a 30 gallon tank for fresh water. All for deer season.
-
-
I'll make this short. I have been using an electric fuel pump on my c-20 over 10yrs. Just recently i had fuel supply problem it would...
-
Camar068 replied to the thread ls swap water- camaro pump?.@plugugly I ran the pump that came with the engine and running the stock square radiator. I had a port soldered in the radiator tank...
