CalSgt's latest activity
-
CIn high school, I had a ‘76 Nova with a 305 2 bbl. Right after my dad and I got it on the road and I started driving it, the single...
-
CWell , 52 year old Grit dog decided that 10 year old grit dogs favorite exhaust was the quick and easy answer. Side pipes ftw!
-
C4 speed would hold up I'm sure, but most likely not what you want. Your only option really is a t56. You're not going to get what you...
-
CCalSgt replied to the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC.Great write up! I went through this when I did the L31 for the Squircle. Getting them apart with the oil varnish groove is a PIA, but...
-
CCalSgt reacted to RanchWelder's post in the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC with
Like.
When it's time to re-assemble each clean dry piston, spring, plunger and stainless cap, make use of a hex nut driver, so you can squeeze... -
CCalSgt reacted to RanchWelder's post in the thread Disassemble Clean Roller Lifters, for L31 Vortec SBC with Like.
Cleaning your roller lifters can go a long way to saving money on a rebuilt Roller Engine. First carefully remove the clips with a pick...
-
CCalSgt replied to the thread 5.3 LS SWAP 82 C10 QUESTIONS.I know Holley makes retrofit fuel pumps with a big sock on the bottom that works without baffling. They were stupid expensive when I was...
-
CCalSgt reacted to RattleSnack's post in the thread 5.7 back fires through carb but timing is good. with Like.
Looks like you tried all the usual suspects... Did you double-check your spark plug wires? Maybe you got some mixed up. My next guess...
-
CCalSgt replied to the thread Has anyone done an L31 Vortec swap?.Thanks for the compliment…
-
CHoly crap. I'm at reply 300. This thing is AMAZING. As much as I want to go all in on it, sitting idle for 15 years so far, I just...
-
CMy 88 has a cable speedo. I'll have to check the build thread later, that's exactly what I envisioned!
-
CI've got an 88 R30 cab I'm putting on my 80 K20 chassis. I've got the dual tanks, switch valve, lines, and the complete tbi harness to...
-
CHoly crap! We ain't seen you around here in a coon's age! You even still have your original signature picture thing! Those are a relic...
-
CCalSgt replied to the thread Has anyone done an L31 Vortec swap?.Yup… L31 & 4L60e in an ‘80 K-10, I did my best to keep it factory looking and mostly GM parts. I’d say the biggest things to overcome...
-
-
CWas going to make a new post till I found this thread. Engine is a 1981/or 82 6.2 diesel, distributir vacuum pump finally died on me...
