bucket's latest activity
-
Yes and no, the front springs and hardware will fit your Blazer HOWEVER, the rear u-bolts and 56" springs will not. The rear u-bolts... -
bucket replied to the thread Best way to transport 19 55 gallon barrels?.I believe it was probably both of us that would have mentioned treating the wood with diesel. For your trailer connector, you can get a...
-
bucket reacted to legopnuematic's post in the thread Searching for My Dad's 1979 Chevy Suburban with
Like.
On a straight axle truck you can get pretty close with a tape measure. Make a reference mark on each tire and tape measure across from... -
bucket reacted to legopnuematic's post in the thread Searching for My Dad's 1979 Chevy Suburban with Like.
How much is the truck lifted? I believe after 4" crossover steering is recommended. I'm sure there were/are plenty of trucks that are...
-
bucket reacted to idahovette's post in the thread What have you done to your square lately?? with Like.
@Mr Clean is that a Buick??.....NOT your Father's??
-
I didn't change them at all. The 05 core support is mostly in place. The rad, intercooler, shroud etc all are mounted as they left the...
-
bucket replied to the thread Ignition control module dwell programming.I feel like this is a question that @Ricko1966 may have an answer to.
-
bucket replied to the thread Finally got a running 65 C10.Ok, I'm really curious as to HOW you did that? Personally, I'd run it. I'd say there's a 99.9999% chance that it would never cause an...
-
I suggested 200 because it's literally a few hours swap you even reuse the driveshaft.
-
bucket replied to the thread Which dually - 8.1 vs pre-DEF 6.6?.I don't know about getting "walked on". Power is power, a lot of people have it in their mind that if something does a job at 2500 rpm...
-
Don’t think I have any pictures but the two 9.5s I had taken apart it G80 Gov Bombs, both of them had chipped or missing teeth in the...
-
Woo-hoo! I'm legit not a freeloader! Long overdue. TBH, my major issue was with online transactions in general and PayPal in...
-
Mounts and spring perches will need to be cut off and have new ones welded in in the correct locations.
-
I believe we found our burb. Will know by tomorrow after we look/purchase.
-
bucket reacted to SirRobyn0's post in the thread Double Dingo's 1965 3/4 Ton "Crusty Biscuit" with Like.
I just want to say that I really enjoyed catching up in your thread and it's good to see you getting going here!
