bucket's latest activity
-
My new vice made in Germany. Lots of forged parts with no play in any moving part. Nice detail: it can be driven with a 1/2 inch ratchet... -
bucket replied to the thread 454 engine rebuild and intake gasket leak.Hopefully the intake face of the heads were not machined as that can make it more likely for the intake to have fitment issues.
-
bucket replied to the thread Car Hauler tips/tricks/ideas.Personally, I wouldn't worry about the underside of the wood. Most trailer decks rot from the top only. I know of many people that...
-
bucket replied to the thread What have you done to your square lately??.Our '12 F350's at work are the same way. Somewhere around 60k, they started leaking from the left lower corners. Sometimes they don't...
-
Yes but that’s less than an inch offset so effectively less than half inch offset in the driveshaft. If the OP pic is 100% correct...
-
IIRC, .060 plug gap was an early spec for HEI, maybe when they were trying to improve the burn for emissions. Later on they found it...
-
There is definitely a difference between Delco Modules and all others. A Delco will always saturate a Delco coil correctly. It will...
-
bucket reacted to CalSgt's post in the thread Best header back exhaust package for a 1985 K10 short bed with
Like.
IIRC the difference between a LB or SB kit is the length of the first straight section as it leaves the mufflers. Many kits just require... -
bucket replied to the thread A very expensive and dumb mistake.It kinda seemed like the entire pumpkin might be shifted over a bit? I dunno, I guess I've never paid much attention to how much of a...
-
All 14 bolts are offset like that and are in literally millions of squares. Don’t sweat it and run it. Just to say it out loud, since...
-
So long as the angle at one joint matches the angle at the other it’s all good! No different than the downward angle from the trans to...
-
bucket replied to the thread How to ID 16" 8 bolt wheels?.I wouldn't say nobody.
-
Yes those are GMT 400/OBS 8 lug wheels. I have a set of my crew cab. They use a stainless steel trim ring and a plastic center cap...
-
bucket replied to the thread 454 engine rebuild and intake gasket leak.Typically with used heads and/or intake, it's best to smear a very thin coating of rtv around the coolant ports, to prevent minor leaks...
-
bucket replied to the thread What have you done to your square lately??.I'm not sure what's going on here, but that's an impressive collection of carburetors.
