Bowtie-dad's latest activity
-
Bowtie-dad replied to the thread What have you done to your square lately??.Sounds like it would be easier to find someone with a GM tech 2 hand held scanner or a scanner with OBD1 capability -
In place of frame rivets, I much prefer to use grade 8 flange bolts, along with hardened, pinch lock, flange nuts.
-
Bowtie-dad replied to the thread Need help identifying sloppy driveshaft/diff play!.Next step is pull the diff cover and check the cross pin and the mounting area where it rides. If that's cracked or worn a carrier...
-
Bowtie-dad reacted to Truck82's post in the thread Need help identifying sloppy driveshaft/diff play! with
Like.
This is where the problem is then. I have quite a bit of movement when doing this -
Bowtie-dad replied to the thread Any R/V crew cab guys? I'm new here.Mines one year only deal first year 454 TBI with 4L80E np205 60 King pin front and 70hd rear.
-
-
Bowtie-dad replied to the thread Need help identifying sloppy driveshaft/diff play!.That's a strong axle. I believe the backlash is supposed to .005-.008 inch. That's what I always set mine to with the 4.10 carrier. You...
-
Bowtie-dad reacted to Truck82's post in the thread Need help identifying sloppy driveshaft/diff play! with Like.
14 bolt SF
-
Bowtie-dad replied to the thread K10 burb shackles vs k20?.I used grade 8 hardware on mine, tractor supply sells it by the pound safer bet.
-
Bowtie-dad replied to the thread What have you done to your square lately??.I just did that. Along with a good time up using 500 ohm per foot 10 mm wires ceramic boots and pulstar fine wire plugs. Spendy upgrade...
-
Bowtie-dad reacted to JamesSam's post in the thread What have you done to your square lately?? with Like.
I have watched a video on rebuilding the TBI. I plan to do this. Maybe now is the time.
-
Bowtie-dad replied to the thread What locker shall I go for?.Detroit tru-trac locks when needed unlocks when not. Eliminates the spider gears and is far stronger. I have this carrier in a 91 v35...
-
Bowtie-dad replied to the thread Looking for a "good" used 30 spline front output NP205 CV Flange yoke for my 1981 K30.Denny's driveshafts
-
Bowtie-dad replied to the thread need help, i have a front drive shaft i think is from a 1 ton from the 80s the markings on the joint are 51 and 601 on the Yoke any help 4x4.You can at Denny's driveshafts or on Dana's website. Those are part number for u joints I believe or yokes
-
Bowtie-dad replied to the thread Need help identifying sloppy driveshaft/diff play!.Worn carrier bearings, pinion bearings, stretched chain in case. Most likely pinion. What differentials do you have?
-
Bowtie-dad replied to the thread Front Driveshaft Question.Yes, that is called a dust shield and they are available through Denny's driveshafts in splined and non splined variety. Just have to...
