Bextreme04's latest activity
-
Damn this whole thread outta be pinned for any future 60e 4x4 swappers haha -
I have a tuner lined up to get me started but feel i need to do my homework as well. Which hasnt been easy. I expect to get into some...
-
Bextreme04 replied to the thread 04 LM7 into 87 K5.Yes. The issue would be if you are planning on using an electronic speedometer. If you are keeping the mechanical speedo on the output...
-
Bextreme04 replied to the thread 04 LM7 into 87 K5.Pin 71 on the blue connector(C1) can be provided with a momentary ground to trigger Tow/Haul maps and Pin 16 on the green connector(C2)...
-
Bextreme04 replied to the thread 04 LM7 into 87 K5.You can... that's what the 4lo switch is for. You can also set "normal" and "performance" shift points using a tow/haul type momentary...
-
Bextreme04 replied to the thread 04 LM7 into 87 K5.You have to think about what the PCM is seeing compared to what the vehicle is actually doing. If you have the VSS at the transfer case...
-
-
Bextreme04 replied to the thread 04 LM7 into 87 K5.If you are picking the VSS signal off before the T-case, then it won't matter if you are in 4-lo or 4-hi. The shift schedule is based on...
-
Bextreme04 replied to the thread What have you done to your square lately??.Speedway an Amazon both sell them as well. $1.99 each at speedway...
-
Bextreme04 reacted to Johnny Atomic's post in the thread What have you done to your square lately?? with
Like.
I don't think any two pieces of trim inside my truck are the same color. And it is 100% orig, It never did match. -
Bextreme04 replied to the thread Quadrajet Primary Shaft Bushings.Gravity... If there is any little bit of a leak on the check valve in the pump, it will siphon the fuel right down to the air break...
-
Bextreme04 replied to the thread Quadrajet Primary Shaft Bushings.The windowed seat does allow more flow, which is good for performance builds, but the downside is it can allow the bowl to drain back...
-
Bextreme04 replied to the thread Drive shaft too short.It's impossible to tell from your pics if it is even short. You should be able to unhook the driveshaft from the axle and then bottom...
-
Bextreme04 reacted to 87scotty's post in the thread Th400 4x4 core possibly axles and body parts with Haha.
Little late on my response still got them on my wall I'm between peoria and lincoln.
-
Bextreme04 replied to the thread Rochester Quadrajet Woes.Its not "air" that you need. It's "compression". Yes.. you do need air, but if it is being allowed to come in to the engine at the wrong...
-
Bextreme04 replied to the thread Rochester Quadrajet Woes.Its not that you NEED the fiber floats. What he is saying is that they react differently and if you don't know what you are doing it...
