Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
Registered members
Current visitors
Menu
Log in
Register
Install the app
Install
Members
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Bextreme04's latest activity
Bextreme04
replied to the thread
Quadrajet Primary Shaft Bushings
.
The windowed seat does allow more flow, which is good for performance builds, but the downside is it can allow the bowl to drain back...
Dec 11, 2024
Bextreme04
replied to the thread
Drive shaft too short
.
It's impossible to tell from your pics if it is even short. You should be able to unhook the driveshaft from the axle and then bottom...
Dec 11, 2024
Bextreme04
reacted to
87scotty's post
in the thread
Th400 4x4 core possibly axles and body parts
with
Haha
.
Little late on my response still got them on my wall I'm between peoria and lincoln.
Dec 10, 2024
Bextreme04
replied to the thread
Rochester Quadrajet Woes
.
Its not "air" that you need. It's "compression". Yes.. you do need air, but if it is being allowed to come in to the engine at the wrong...
Dec 9, 2024
Bextreme04
replied to the thread
Rochester Quadrajet Woes
.
Its not that you NEED the fiber floats. What he is saying is that they react differently and if you don't know what you are doing it...
Dec 9, 2024
Bextreme04
reacted to
Ricko1966's post
in the thread
What new tools have you got lately?
with
Haha
.
" then" not than. Spell check police are going to get you.Did you go to school?
Dec 4, 2024
Bextreme04
reacted to
gmbellew's post
in the thread
What have you done to your square lately??
with
Like
.
it is so dark inside the cab of these old rigs, and I could never see the cupholders on the center console of the suburban. One good...
Dec 4, 2024
Bextreme04
replied to the thread
Rochester Quadrajet Woes
.
To mimic the OEM electric choke trucks, it is recommended to wire that through an oil pressure switch. This will only provide power to...
Dec 3, 2024
Bextreme04
replied to the thread
Rochester Quadrajet Woes
.
The electric choke conversion for your Q-jet just replaces the thermostat bolted to the manifold with an electric one. You don't...
Dec 3, 2024
Bextreme04
replied to the thread
Fuel problems
.
It sounds like you have the return lines swapped on the valve or the valve is not switching properly. Make sure that the feed and return...
Dec 3, 2024
Bextreme04
reacted to
75gmck25's post
in the thread
Rochester Quadrajet Woes
with
Like
.
Take a close look at the throttle linkage side of the carb and get the Quadrajet number. This tells you which carb you have (original...
Dec 3, 2024
Bextreme04
replied to the thread
Rochester Quadrajet Woes
.
This is a pretty good description of what should be happening, but I'll add a few caveats. Early quadrajets like this one only had one...
Dec 3, 2024
Bextreme04
replied to the thread
Big block running hot. Can’t figure out the issue
.
oof... bummer. Glad you checked it though. If you had it dialed in near sea level and are now in Denver, I would start by dropping 2 jet...
Dec 2, 2024
Bextreme04
replied to the thread
4.8/5.3 to 383
.
You aren't going to get 383 actual displacement from an LS unless you start with an actual LS1. The math just doesn't work out for any...
Dec 2, 2024
Bextreme04
replied to the thread
Big block running hot. Can’t figure out the issue
.
Not necessarily. 14.7:1 is stoich for pure gasoline. Pure ethanol is 9.003:1. Almost all gasoline sold in the US is now E10(roughly 10%...
Dec 2, 2024
Latest posts
Quick and easy engine rear support when transmission is removed?
Latest: Logbed
Today at 2:26 AM
Engine Swaps (Gas) LS, Vortec, LT1 , etc.
Whip antenna for CB on a Suburban
Latest: Radiohead
Today at 2:07 AM
Retro-Fit & Aftermarket Accessories
What have you done to your square lately??
Latest: Grit dog
Today at 1:37 AM
Garage
Factory Paddle/Dumbo Mirror Mounting Reference
Latest: ali_c20
Today at 1:05 AM
Glass & Mirrors
Exhaust collectors for manifolds
Latest: ali_c20
Today at 1:00 AM
Engine & Performance
Forum statistics
Threads
44,756
Posts
967,426
Members
37,482
Latest member
Okla homie boy
Members
Top