beady's latest activity
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.I had an OTC scanner that would show you data. But not graphically, and it got stolen. I ordered an ALDL usb cable yesterday... -
beady reacted to Bill USN-1's post in the thread 1987 454 TBI stalls at idle after a short time with
Like.
Here's my reply to you msg on binderplanet.com ____________________________________ Best to post in the injection forum then PM... -
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Well…. I went to check timing (it was about 20 degrees btdc) and I pulled the timing connector wire to check base timing and the engine...
-
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Thanks for that. However, since I complained the truck has been running normally, go figure. I’ve done probably 8 dead cold to...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.Thanks for the detailed reply. I had a scanner that would give ALDL live data until about a week ago. My son borrowed it for his...
-
beady reacted to fast 99's post in the thread 1987 454 TBI stalls at idle after a short time with Like.
FYI, TBI primarily uses MAP for fuel trim. O2 sensor only effects trim after reaching operating temp and usually will not stay hot...
-
beady reacted to Vbb199's post in the thread 1987 454 TBI stalls at idle after a short time with Like.
If you had a means to scan the obd1 interface, you could check manifold pressure.... but since those all seem to be gone from the...
-
beady replied to the thread 1987 454 TBI stalls at idle after a short time.MAP sensor is a couple months old, a couple hundred miles old, tops. I haven’t tried spraying starting fluid around intake to check for...
-
Hello again, I have this new to me 1987 454 TBI suburban that I’ve been chasing problems down in. Today’s issue is stalling after a few...
