BadBowtie's latest activity
-
BadBowtie reacted to Chris64's post in the thread Removing instrument panel - dealing with the oil pressure line with
Like.
This is a good description of where I'm at now. Dash pad, glovebox and bezel removed. left and right plenum's removed. Now I need to... -
BadBowtie reacted to bucket's post in the thread Removing instrument panel - dealing with the oil pressure line with Like.
I've always removed the oil line from the back of the cluster. I don't remember it being difficult, but it's been a number of years...
-
BadBowtie reacted to 75gmck25's post in the thread Removing instrument panel - dealing with the oil pressure line with Like.
I’ve always disconnected the oil line in the engine compartment. It’s not real hard to reach, and the two nuts for the compression...
-
BadBowtie reacted to PrairieDrifter's post in the thread Removing instrument panel - dealing with the oil pressure line with Like.
You don't need to pull the cluster to work on the hvac. Everything should come out the bottom of the dash. May have to pull the bezel...
-
BadBowtie reacted to Chris64's post in the thread Removing instrument panel - dealing with the oil pressure line with Like.
This is a strange thing that I haven't found any help on the internet at all. It's a 1974 K-20. I was trying to remove the instrument...
-
If it helps here the part number on mine.
-
I believe the TBI snorkel tubes are a bit longer because the air cleaner housing locks down onto the TB in a certain position, where the...
-
I was having a problem finding one for my 87 v10. I ended up getting one at a junkyard. It was pretty dry rotted in places. I ended up...
-
Will try to remember to look when I get home, but may have an 87 hose still from a truck that was 5.3 swapped.
-
Thank you Dwight! I've been looking for this hose.+ Ordered one for my 1985.
-
My air cleaner is a '87 big block version and I suspect the opening is different from the 350 version, but I can take some measurements...
-
Found it, This thread post #9
-
Someone here I think was 3d printing an adapter for those air cleaners.
-
Ebay was a bust...could only find a few very high priced ones off a G10 van...not the same.
-
This is my air cleaner housing and the accordion piece that came with this truck may not be right. It is only about a foot long and...
