AZ Highlander's latest activity
-
AZ Highlander reacted to JamesSam's post in the thread What have you done to your square lately?? with
Like.
That's what I'm doing. -
AZ Highlander reacted to kapitein's post in the thread 86 Suburban 2nd row shouldber belts with Like.
Update to this. Finally got the rear belts in the car. I waited until the car was off the road for the winter anyways.... So, they...
-
AZ Highlander reacted to kapitein's post in the thread 86 Suburban 2nd row shouldber belts with Like.
I finally got around to ordering these...
-
AZ Highlander reacted to Ricko1966's post in the thread 86 Suburban 2nd row shouldber belts with Like.
Used seat belts don't rate high on my list of good ideas. They are all,decades old and if you ever buy new sfi seat belts you'll find...
-
How to hold the fuel pump rod in while installing the fuel pump. Not my work, but a great tip
-
Here’s another power window trick, I just remembered that works for a lot of different vehicles and saves a lot of misery. 1: make...
-
No need for "the tool". Use an old rag or t-shirt. If you slip the edge of the rag/t-shirt between the door panel and the window crank...
-
If your truck won't turn over at all, try reaching around with your left hand and pulling the gear shift farther into the park position...
-
Steel Wool works wonders on glass also!
-
Did you know, the galvanized ashtray can be polished to a bright shine? A bench polisher and a fine abrasive (Tripoli). It’s an easy way...
-
Turn any nut and bolt into a Nylock. Cut a small piece of fishing line. Put it through the nut, tighten down the bolt. Works great on...
-
It will be an ACDelco R45TS. That was the specified plug for almost every small block(and some big block) GM engine for decades. My 71...
-
ACDELCO. Gap is .045 with HEI if I recall correctly, and .035 with points. Go to the local auto parts store, rock auto, or whatever...
-
AZ Highlander reacted to ChuckN's post in the thread What have you done to your square lately?? with Like.
Drove the truck to my knee appointment after going one step leaner with the metering rods- big mistake! Way too lean. But interesting to...
-
AZ Highlander reacted to Chevrolado's post in the thread What have you done to your square lately?? with Like.
Why is it the simple little things that are so entertaining to me... :D Got the rubber stopper (only one tab left on my tray) and new...
