animal's latest activity
-
Well. Threw it back together and took it for a drive. It has a noise. A worse noise than before :bs: Not a horrible noise, it’s not... -
animal replied to the thread New FL K5 here.:welcome:
-
Ok, I’m done screwing with the rear axle. Tried 4 more setups today and never could get any better than the one from Sunday. Put the...
-
So every single person I got their opinion on my setup stated they felt it was a touch shallow, but would run it if I was out of shims...
-
animal replied to the thread New project owner.:welcome:
-
So I decided to hold where I was before making any more changes and get some opinions/insight from Spencer and some others that are more...
-
Hokay. So. Went to the shop again today to play with this some more. Took some backlash measurements before anything else. Backlash...
-
Well, got it back together again. The ring gear is still 100*+ so I’m taking all of this with a grain of salt and not making any more...
-
Lost 1.5hrs shooting the **** when a buddy came by, fiddled with some shims to see if I could cheat rather than flipping the gear. Could...
-
Back on this today. Decided to do some learnin' since I've already been down this long, what's another day or so for educational...
-
animal replied to the thread Hello everybody!!!.:welcome:
-
animal replied to the thread Hello from Northern MA!.:welcome:
-
Then here's the drive side Pre-change/teardown on the left, new setup on the right
-
So I decided to paint and run a pattern every 90* just to see. These are all coast side This is pre-change/during teardown on the...
-
Unfortunately my bearing puller tool clamshell wasn't quite the right side for these Koyo bearings, it slipped and messed up the cage...
