ali_c20's latest activity
-
ali_c20 reacted to SirRobyn0's post in the thread Differential swap / bought it, work and install now with
Like.
In the brake department my basic plan is to pull both sides apart, (which reminds me I need to bring my socket for the bearing retainer... -
ali_c20 replied to the thread Differential swap / bought it, work and install now.Regarding the brakes: On the old FF axles you have to remove the hub to access the brake shoes cause the wheel studs are pressed in thru...
-
ali_c20 reacted to Ricko1966's post in the thread Problems with Fit on not one, but two new rear bumpers for 78 C10 fleetside with Like.
Does the bow come out with the bumper bracket bolts loose? As in do you maybe have tweaked frame rails or bumper brackets. If the bow...
-
I get that square dually beds are getting harder to find but trust me, neither bed is going to look decent on there. Nothing lines up...
-
No
-
Good morning group. Has anyone replaced the tranny cross member with an aftermarket unit? I'm getting fed up with the tight space...
-
ali_c20 replied to the thread Aftermarket tranny cross member.Dirty Dingo. https://www.dirtydingo.com/shop/product_info.php?products_id=1795...
-
ali_c20 replied to the thread Bulkhead Connectors.Yeah, saw it, but its gone anyways. Dang. Can't get ebay links to work.
-
Thanks, The Ebay link wont work for me. I was kinda smart when i had the box off i ran all new wire inside a3/4 inch conduit to a...
-
ali_c20 reacted to TheHoundsman's post in the thread Searching for My Dad's 1979 Chevy Suburban with Like.
Good morning guys. I am hoping to get a little more advice or information from the group. I am installing a cross over steering system...
-
ali_c20 reacted to TheHoundsman's post in the thread Searching for My Dad's 1979 Chevy Suburban with Like.
This is the gauge cluster I bought
-
You can use a heated O2 sensor. You will have to wire up the heater circuit but that would not be hard to do.
-
Maybe install an O2 sensor that comes from the factory with a heating circuit? So the sensor heats itself up on its own. You would have...
-
ali_c20 replied to the thread Bulkhead Connectors.In that case a new harness doesn't make sense. Found the connector NOS on ebay, pricey.... Clips and fasteners has a lot of oem...
-
ali_c20 reacted to 82scottsdale62's post in the thread Let's see those 4x4 Squares On Dirt! with Like.
More mud than dirt out here in the pacific northwest right now. But here's a picture of my truck on my buddies farm
