ali_c20's latest activity
-
ali_c20 replied to the thread Wiring Harness? Choosing one?.I used painless harnesses for my wifes 69 Mustang and a friends 77 K5. Installation was easy. Instructions are good and the customer... -
Thank you for your replies, gentlemen. I debated how much to put in my OP, but I guess there are a lot of factors I'm trying to weigh...
-
ali_c20 reacted to idrivea2002golf's post in the thread Gas to Diesel swap, question on fueling with
Like.
:emotions133: I'm leaning toward to the dual. Doesn't seem any more expensive than a quality inline. And I have the bed off so access... -
A 14 bolt semi floater (9.5") from a K1500 "heavy half" gmt400 pickup is a 6 lug axle. A little wider than a square body axle (it makes...
-
Okay it's the bolt in the diff that holds the cross pin,they always break if you don't heat them with propane before trying to remove...
-
ali_c20 replied to the thread Gas to Diesel swap, question on fueling.When you rip it out of a Ford truck it's a ford part ;D The dual intake pump setup is the best solution imo.
-
ali_c20 reacted to idrivea2002golf's post in the thread Gas to Diesel swap, question on fueling with Haha.
Not to split hairs... but TECHNICALLY it's an International Harvester part connected to a ZF part connected to a Borg Warner part. :D...
-
ali_c20 reacted to AuroraGirl's post in the thread Gas to Diesel swap, question on fueling with Like.
if you use the original fuel pump on the engine, you should use the ford pollack valve, since it was designed to suck diesel through...
-
ali_c20 reacted to AuroraGirl's post in the thread Gas to Diesel swap, question on fueling with Like.
https://www.strictlydiesel.com/product/4543/selectable-restriction
-
ali_c20 reacted to idrivea2002golf's post in the thread Gas to Diesel swap, question on fueling with Like.
Red3833's post with the diagrams and explanation of using the sniper output is kind of the swap I was thinking about doing. I...
-
ali_c20 reacted to Turbo4whl's post in the thread Spare tire carrier? DONE, installed an in bed carrier with Like.
The glide out carrier was an option, so if your truck had that it would show on the RPO sticker. The bed carrier is better for your...
-
ali_c20 reacted to pinballlarry1's post in the thread Spare tire carrier? DONE, installed an in bed carrier with Like.
Installed this one from LMC truck, very happy with it:
-
Thanks everyone, I will leave as is
-
ali_c20 replied to the thread Hello from AZ.Welcome from Austria.
-
Hello from Catalina, Arizona! Just purchased a 91 Suburban.
