ali_c20's latest activity
-
ali_c20 reacted to 82sbshortbed's post in the thread What have you done to your square lately?? with
Like.
Painted the air filter lid satin black. The aluminum was just not cutting it. Even after cleaning it up. -
Grabbed one of these last weekend to do my steering wheel finally. Quality is decent truth be told.
-
ali_c20 replied to the thread 1984 Winnebago Elandan 31ft Class A Motorhome w/ Chevy 454 Big Block 7.4L Engine Owner in need of engine part identification/emissions hose help..Welcome. Post pics from the engine and parts you don't know, than it's way easier to give advise what has to be used and what can be...
-
^^^^ this. You'll spend 1/3 on fuel as you will if you big block swap. And a 6.2 will pull anything you put behind it.
-
Howdy from Ohio! How long have you had it? If you drive it a bit more, you may find that you actually like the 6.2, along with it's...
-
Howdy! I just picked up my first square body three weeks ago. I picked up a 1988 chevy v10 suburban, this is my daily driver and it's a...
-
ali_c20 replied to the thread First Square body!.Welcome from Austria.
-
I installed mine with the exhaust manifolds already bolted on. It worked fine, but it was a PIA to jockey it around to line up and...
-
I went through this on my 85 with the help of Magnaflow engineers. Bottom line, if the cats don't get hot enough to fire off, it's all a...
-
In an S2000 I had some time ago an electric pump run for a minute after a cold start on a timer and it shut off during acceleration. I...
-
Yep.
-
I would say absolutely. K
-
ali_c20 replied to the thread Engine install.Yes. More space to work on the engine mounts without them.
-
ali_c20 replied to the thread 1991 c1500 rear axle to 1987 r10.Welcome from Austria. Post some pics. Transmission is direct fit if both trucks have the same transmission. Driveshaft length. Axle...
