ali_c20's latest activity
-
I have stock suspension on my 83. I’m running 275/60-15 front and rear and haven’t had any issues. BUT just to be sure try your rear... -
I had my 15x8 rallies powder coated to match the neutral body color. To me, it looks way better than the argent color, it's unique, and...
-
ali_c20 reacted to boloboss's post in the thread The squeaking is getting on my last nerves with
Like.
Waz up Guys. The fix to my squeaking lower control arms was faulty grease fittings not taking in the grease. Cost me $7 plus my... -
ali_c20 reacted to Normmus's post in the thread The squeaking is getting on my last nerves with Like.
Did you use urethane bushings or rubber bushings? I've heard that the urethane ones can be loud if not sufficiently greased on installation.
-
ali_c20 reacted to CountKrunk's post in the thread The squeaking is getting on my last nerves with Haha.
Crank your music up haha
-
ali_c20 reacted to Dezzracer's post in the thread Rebuilt Stock Steering Column or Aftermarket? with Like.
I vote rebuild the OE column. Regarding China parts I have two stories about my frame off resto of 76 GMC 4x4 short bed. We ordered new...
-
I used these in the factory metal "clam shells" for my 78 C10 ...
-
I think it always pay off to go with new, but spend some time looking for a higher quality product. Maybe the off-road vendors sell...
-
I usually replaced the mounts. Many times upper bracket attached to the block will be laying hard against the cross member or frame...
-
I have heard two opinions 1. Old OEM after 40 years is still better than new chinese 2. Replace them as the engine is out now. Its not...
-
ali_c20 replied to the thread Engine mount, old or new?.Rubber ages and with 40 years it's pretty dead. I had to replace the engine mounts on all old vehicles I owned. Some were terrible worn...
-
Yes that's the part. I'll send them an email and check, all the others I've found have been for the 11 inch.
-
ACDELCO. Gap is .045 with HEI if I recall correctly, and .035 with points. Go to the local auto parts store, rock auto, or whatever...
-
Yes, that is called a dust shield and they are available through Denny's driveshafts in splined and non splined variety. Just have to...
-
The dash controller has to match the large vacuum switch bolted on the back (it’s visible in the photo of the newer switch). You...
