ali_c20's latest activity
-
And a trick to break these type of gloves in easier is spray some brake cleaner on the rubber part and rub your hands like a bar of... -
ali_c20 replied to the thread Little help please.Welcome from Austria. Build it stock. Summit has nice brass copper original fit radiators
-
I'd go back to a stock water pump,a thermostatic mechanical fan,a stock radiator and shroud.
-
Hi everyone I just joined the forum, here is my truck. Been building it for about 3 years, saved it about 6 years ago. Was on its way to...
-
Been working on this 85 for a year now. Started out as a 2500. Swapped body and drivetrain over to a SWB 1500 frame. Just need a vision...
-
THAT'S IT???????....only 2 pics??........more pics..............you're what we used to call some girls in high school........... A PR!CK...
-
When I get to that point, I'll see how the 2 piece seal fits on the spindle. They are supposed to lock on the spindle and the hub side...
-
I always polish seal contact areas even with a worn grove, with 400 grit wet or dry sand paper, make sure the grove area gets good...
-
ali_c20 replied to the thread Headlight wiring harness.Get a relay harness or diy one. Takes the load of the headlight switch...
-
ali_c20 replied to the thread New Member, Southern Oregon.Welcome from Austria. Nice seats.
-
ali_c20 replied to the thread This is an awesome site. Glad I found it..Welcome from Austria.
-
ali_c20 reacted to bucket's post in the thread Changing gear ratios: opinions/suggestions wanted!! with
Love.
I don't understand why everyone says they can't keep up with modern traffic. Why the heck not? Just get on the skinny pedal and let it... -
ali_c20 replied to the thread Olds 350 diesel to sbc swap.Welcome from Austria. Nice truck. Remove diesel, fill up with gas. Done.
-
Correct. Full time hubs weren't used after the '79 model year. At any rate, you can replace full time drive slugs with manual locking...
