84_c10_GMC's latest activity
-
8If it is starting its getting 12 volts at cranking,if it starts and continues to run a few seconds after you release the key it's still...
-
884_c10_GMC reacted to JamesSam's post in the thread What have you done to your square lately?? with
Like.
I have watched a video on rebuilding the TBI. I plan to do this. Maybe now is the time. -
8Replace all four hinge pins and bushings. Then adjust doors accordingly. You adjust them by loosening the bolts until they're just snug...
-
8Your strikers aren't in terrible shape. Usually the door pins need to be replaced assuming the doors haven't been completely removed...
-
8It will be an ACDelco R45TS. That was the specified plug for almost every small block(and some big block) GM engine for decades. My 71...
-
8ACDELCO. Gap is .045 with HEI if I recall correctly, and .035 with points. Go to the local auto parts store, rock auto, or whatever...
-
81978 Chev 350 factory gap is .035"
-
884_c10_GMC reacted to Mr Clean's post in the thread What have you done to your square lately?? with Like.
I'm not trying to be an a$$, but as much time, money and worry you have put into the old TBI have you thought about upgrading to a newer...
-
884_c10_GMC replied to the thread What have you done to your square lately??.New harness is installed, just need to get starter back in and wired up. Still need to pull new wire for fuel level to tank, and hooked...
-
884_c10_GMC reacted to Mr Clean's post in the thread What have you done to your square lately?? with Like.
Cut off the rear portion of the taillight, and all of the rot. Started welding in a better section.
-
884_c10_GMC reacted to Ricko1966's post in the thread One more electrical plug identification with Like.
1/8th npt is standard plumbing fittings,you can get fittings at the hardware store.
-
884_c10_GMC replied to the thread One more electrical plug identification.Yea figured that out after I looked again. I’ve got a new fitting on the way to put both sensors there. As I have been unable to get...
-
884_c10_GMC reacted to Ricko1966's post in the thread One more electrical plug identification with Like.
At the distributor it's 1/8th 27 npt.
-
884_c10_GMC reacted to Ricko1966's post in the thread One more electrical plug identification with Like.
Standard ignition ps126
-
884_c10_GMC replied to the thread One more electrical plug identification.Sounds good thank you! And yes I’m pretty sure one by distributor is 1/4” npt . But this block is an older block, 73, so I may need to...
