84_c10_GMC's latest activity
-
884_c10_GMC reacted to Camar068's post in the thread Fuel gauge to tachometer, clock to fuel gauge with
Like.
ah...sorry about that, I didn't realize your initial pic had the gauges in it. They look nice. And from the looks of it, the LMC tach... -
884_c10_GMC reacted to cmichels83's post in the thread Fuel gauge to tachometer, clock to fuel gauge with Like.
Glowshift sells a small one that will fit if you cut the whole for it. I replaced everything but the fuel gauge. Put the tach in the...
-
884_c10_GMC replied to the thread Fuel gauge to tachometer, clock to fuel gauge.I’ll have to take a look but I didn’t think the summit gauges looked half bad for an oem style. LMC maybe cheaper though.
-
-
884_c10_GMC reacted to Camar068's post in the thread Fuel gauge to tachometer, clock to fuel gauge with Like.
LMC has gauges that will be a closer match. Stock gauges
-
884_c10_GMC replied to the thread What have you done to your square lately??.Alright snapped a few photos before I run to orielly. Thing I hate the most is previous owner swapped the core support for the 88-91...
-
-
8I have true duals in my 78, and have had duals in a couple other trucks. At this stage in life, I would just replace the muffler and be...
-
884_c10_GMC replied to the thread Exhaust Question.I’ve always been a fan of flow masters but I haven’t bought anything in a good bit. The last time I did I happened to get the last set...
-
8Been a while since I did an update. Even though I bought the 2wd to 4wd conversion kit, we decided to do a frame swap instead. The 2wd...
-
8I agree and this is exactly why I bought an older suburban. Sold my 2020 Yukon because maintenance and repairs on the thing were...
-
8Looks like a very well preserved Burb, good luck with your project! I'm partial to square body Burbs; we've had 5 of them. Two OBS Burbs...
-
8Do yourself a favor, grab any other t-case but a 203.
-
8This is very helpful! Based on the last photo, I am less concerned about the width. Maybe a 1" body lift would be a good option for...
-
8why not just trade the thing for a 4x4 and be done......
-
8I have a 1 inch aluminum puck body lift, the only real issue is the fan shroud, will need trimmed on the bottom. Other than that...
-
8I hate to suggest but How about a small enough body lift to accommodate? Lower the trans/ T-case?
