77Dmax's latest activity
-
777Dmax replied to the thread 84 k5 Stock fuel Guage stuck on 1/4 tank???.Ground the sending unit wire itself.
-
777Dmax replied to the thread 84 k5 Stock fuel Guage stuck on 1/4 tank???.Does it peg to empty if you ground the sender wire? Thats more important than going to full unplugged..
-
777Dmax replied to the thread Big block running hot. Can’t figure out the issue.Most of the holes in the head gasket are blocked or partially blocked to direct coolant flow. The holes in the block are there to remove...
-
777Dmax replied to the thread 350 tbi running too cold.Are you reading the guage or the engine temp with a scan tool?
-
777Dmax replied to the thread First real drive! Not tragic but not good. I think I need carb advice..I think your vacuum leak is under the hood. Check all your hoses and spray some carb cleaner while it's running.
-
777Dmax replied to the thread Check out my rear end.Look at your driveline mounts for wear/play. These engines move all over the under load. Your chattering might be due to the springs in...
-
777Dmax replied to the thread First real drive! Not tragic but not good. I think I need carb advice..You probably have a vacuum leak somewhere.
-
777Dmax replied to the thread WebMonkey's latest melt down, poor ol' me, hissy fit. (yes, I'm WebMonkey).45 Fahrenheit? Thats where I heat my garage at in the winter.
-
777Dmax replied to the thread Repeated stalling.Check the grounds at the t-stat housing and clean the throttle blades. Also clean the egr valve. It's probably stuck open some.
-
777Dmax replied to the thread Changing gear ratios: opinions/suggestions wanted!!.Twenty-five years ago if you would have told me anyone was buying a 3/4 ton truck just to commute with I would have laughed in your...
-
777Dmax replied to the thread No driver's side rear turn signal or brake light, because no power at bulkhead.If you have a tilt column the wire might be broken at the swivel point. Usually there isn't enough space to repair it though. A new...
-
777Dmax replied to the thread No driver's side rear turn signal or brake light, because no power at bulkhead.You probably need a turn signal switch. There are two dogs in the switch that move (literally) between the brake and turn signal input...
-
777Dmax replied to the thread Big block running hot. Can’t figure out the issue.I gotcha. They would have to put the ribbed side to a smooth pulley or vice versa, and that would be hard not to notice. Its a...
-
777Dmax replied to the thread Big block running hot. Can’t figure out the issue.In a serp setup any pulley that is turned by the smooth side of the belt is spinning opposite of the crank, any pulley that is spun by...
-
777Dmax replied to the thread Changing gear ratios: opinions/suggestions wanted!!.I wouldn't put a 700 in a 3/4 ton truck, that's a step backwards.
Latest posts
-
-
-
-
98' Vortec Block, Timing Cover and Balancer Spacing Questions.- Latest: RanchWelder
-
